23
➔ The internal rinsing operation
begins and lasts about 1 minute.
➔ Symbol 17 ‘Empty used coffee
tray / drip tray’ lights up.
➔ Remove and empty the drip and
used coffee trays.
➔ Clean them and replace them
in the machine.
➔ The machine warms up briefly
(Stand-by button flashes) and is
operational again when the Stand-
by button, the bean symbol in the
display and all operating buttons
light up without flashing.
Manual descaling
If required, the descaling program
can be started and run as described
above even if no indication has
been displayed by the machine that
this is necessary. See point 5.3.
5.4 General cleaning
Caution: Never submerge the
machine in water! Do not use
abrasive materials to clean the
machine. Do not put the re -
movable components of the
machine in the dishwasher.
➔ Wash the case inside and out
with a soft, damp cloth only.
➔ Empty the drip tray (fig. 1/J)
and the used coffee tray (fig. 1/T)
only when instructed to do so by
the display. Always empty the
used coffee compartment when it
is removed. Occasionally use
soapy water to clean.
➔ Empty the used coffee tray
thoroughly whenever the machine
has been switched off at the
mains power switch (fig. 1/R).
➔ When the red fill level indicator
for the drip tray (fig. 1/I) becomes
visible, please remove, empty,
clean and replace the drip tray.
➔ The water reservoir (fig. 1/C
and 2) should be rinsed out and
filled up with fresh cold water on
a daily basis.
➔ It is hard to remove dried milk
left on the jet (fig. 1/Q) after
frothing. Please therefore clean
the equipment as soon as it has
cooled down – ideally repeat the
steam drawing operation in a cup
with fresh, cold water and wipe
with a damp cloth.
➔ Note: From time to time, the
steam jet should be completely
unscrewed, dismantled into pieces
and given a thorough clean under
flowing water.
... 5. Maintenance and care
