1 When fi nished scrubbing, press the One-Touch Scrub Switch (I), this will automatically raise, retract and stop all the machine systems (brush, squeegee,
vacuum, solution and detergent. Then drive the machine to a service area for daily maintenance and review of other needed service upkeep.
2 To empty the solution tank:
Direct the Solution Tank Drain Hose (22) toward a designated “DISPOSAL SITE” and open the Solution Drain Valve (34). Also the tank can be drained by
closing the Solution Shutoff Valve (27) and removing the cap from the Solution Filter (26), then open the Solution Shutoff Valve to drain the solution out
through the fi lter. Rinse the tank with clean water.
3 To empty the recovery tank, pull the Recovery Tank Drain Hose (30) from its storage area. Direct the hose to a designated “DISPOSAL SITE” and unscrew
the cap (hold the end of the hose above the water level in the tank to avoid sudden, uncontrolled fl ow of waste water). Unlatch (29) and lift open the
Recovery Tank Cover (13) set the prop rod (32). Inspect and empty the Debris Catch Tray (16) in the recovery tank. Rinse the tank with clean water.
4 Remove the brush or pad holder. Rinse the brush or pad in warm water and hang up to dry.
5 Remove the squeegee, rinse it with warm water and hang it up to dry.
6 Check the maintenance schedule below and perform any required maintenance before storage.
7 Store the machine indoors in a clean dry place. Keep from freezing. Leave the tanks open to air them out.
8 Turn the Key Switch (A) OFF (O) and remove the key.
9 Batteries are the most expensive replacement item on this machine. To protect your investment and to get as many cycles from the batteries as possible,
remember the following:
When installing batteries make certain the machine and charger are programed for the correct battery type.
Batteries will last longer if they are kept fully charged.
Batteries will prematurely fail if stored in a discharged state.
Battery chargers will not over or undercharge the batteries.
Every day after use, the battery charger must be plugged in and the charger must be allowed to run through a full charging sequence to fully charge the
batteries. This may take 8-12 hours depending on the battery status.
Always have the charger plugged into an AC outlet if the machine will not be used for a longer period of time to keep the battery(s) charged.
MAINTENANCE SCHEDULE
MAINTENANCE ITEMDailyWeeklyMonthlyYearly
Charge BatteriesX
Check/Clean Tanks & HosesX
Check/Clean the Brushes/PadsX
Check/Clean the SqueegeeX
Check/Clean Vacuum Shut-Off FloatX
Empty/Clean Debris Catch Tray in Recovery TankX
Check Each Battery Cell(s) Water LevelX
Inspect Scrub Housing SkirtX
Inspect and clean Solution FilterX
Purge Detergent System (if installed)X
Lubrication of MachineX
* Check Carbon BrushesX
* Have an Authorized Nilfi sk Service Center check the vacuum motor carbon motor brushes once a year or after 300 operating hours. The brush and drive motor
carbon brushes should be checked every 500 hours or once a year.
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Nilfisk SC1500 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Nilfisk SC1500 in the language / languages: English as an attachment in your email.
The manual is 16.82 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
