19222
38
Zoom out
Zoom in
Previous page
1/60
Next page
INSTRUCTIONS FOR USE
8 32401106(1)2004-04 A
OPTIONAL EQUIPMENT
The options listed below can be used with the vacuum.
32400150 Dust bag system kit
32400151 Safe bag system kit
32400152 Plastic bag system kit
32400153 Stainless steel container
32400154 Liquid kit complete with stainless steel
container
32400155 Pulse jet cleaning kit
32400156 “M” class filter kit
32400157 “H” class filter kit
32400158 Asbestos kit
32400159 ABS container kit
For information on spare parts please refer to the Spares
Catalogue.
MACHINE EQUIPPED WITH
ELECTRIC FILTER SHAKER
One variant of each type of four machines is equipped with
an electric filter shaker. This consists of an electrical
reduction unit and a lever system that turns the filter in a
horizontal reciprocating way.
Rotary movements are about 10 degrees to the right and
10 degrees to the left with a frequency of about 180 cycles
per minute.
The dust detaches from the filter thanks to the high
number of cycles. The filter is held by a mechanical cage
able to withstand the pressure exercised by the filter itself,
carry the latter when the filter shaker operates and keep it
taut during the suction phase.
Filter cleaning can be programmed at set intervals
regardless of the degree of clogging. It can also be
established by a differential vacuum gauge, which only
activates filter cleaning when there is certain degree of
clogging.
Only entrust inspections and filter replacement operations
to competent personnel.
If work has been carried out on the electrical filter shaker
system, (i.e. replacement of filter or the like), follow the
instructions below.
Once work on the vacuum has terminated and before
closing cover “4”, check that the filter bags “8” and bearing
cage “9” are vertical.
When the Lever “7” fixed to the operating shaft “2” is in the
neutral central position halfway along its travel, connect
rod “5” to the gearbox “6”.
Only in this way will cage “9” cover an equal travel to the
right and left when the gearbox unit is operated.
Shake filter “8” and cage “9” by hand in order to eliminate
any small positioning defects, then tighten the clamp in
filter “8” to fix it in position.
The filter could be torn and the motor of the gearbox burnt
out if this is not done.
Fix the clamp “3” back in place and refit the suction pipe.
The same lever positioning precautions must also be
taken when only the cover is moved and not the filter ring.
EXPLOSION-PROOF VERSION
ATEX
If the vacuum cleaner is used in locations where
combustible and explosive substances are present
Nilfisk-Advance can equip the machine for use in the
categories:
ATEX Zone 21 (Not previously available);
ATEX Zone 22, Class “L”.
Please contact Nilfisk-Advance if you wish to make use of
these options and require further information.
ATTENTION!
Before commissioning the machine you
should always check that the details given
on the data plate on the machine meet the
safety regulations applicable to the
conditions under which the vacuum cleaner
is to be used.
Make sure that the vacuum cleaner is
suitable for operation in the classification
applicable to the surroundings.
If you have any question or doubt, contact
your authorised Nilfisk-Advance customer
service centre before operating the
machine.
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk IV055 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk IV055 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nilfisk IV055

Nilfisk IV055 User Manual - Italian, Portuguese, Spanish - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info