320929
8
Zoom out
Zoom in
Previous page
1/92
Next page
3
become warm during charging. This is not an
abnormal sign.
5. Waste disposal
Try to dispose the vacuumed waste as fre-
quently as possible. The dust attached to the
lter can cause poor vacuuming performance
and stress the motor.
Always switch OFF the power when operating
for disposal.
1. Detach the dust container.
2. Pull out the lters.
3. Empty the dust container.
4. Re-install the lters in correct order and posi-
tion.
5. Re-install the dust container to the vacuum
unit.
Caution
Do not vacuum a lot of dust at one time and do
not vacuum large objects. May cause the suction
port to clog and loose the suction power.
Do not vacuum kerosene, petrol or butts of
smoked cigarettes. This may cause a re.
Dispose dust frequently in order not to damage
the product.
6. Service and
Maintenance
Always switch OFF the power and disconnect
the power plug for the battery charger from the
power outlet before starting maintenance.
6.1 Vacuum Unit, Stick Body, Charging Base
Wipe off any dirt from the product using a dry
and soft rag.
In case of stubborn dirt, clean using a soft damp
rag soaked in a water solution diluted with a little
neutral detergent and then wipe with a dry rag.
Do not use solvents like thinner, benzene, and
spray type cleaners.
6.2 Dust Container
Remove any collected dust inside the dust con-
tainer rst and wash using lukewarm water.
Make sure that the dust container is completely
dry before re-assembling.
6.3 Filter
Do not wash the lters in the washing machine.
Do not dry them using a hot air blower such as a
dryer or a hair dryer.
In case of stubborn dirt or loss in suction power,
wash as instructed below:
1. Remove the dust rst
2. Wash with water
3. Make sure that the lters are completely dry
before the parts are re-assembled.
6.4 Power Brush
Carry out the maintenance if any waste threads
or hair gets tangled in the brush.
Regular Maintenance
Slowly rotate the brush manually and remove
any foreign objects tangled around the brush.
Maintenance when the power brush cannot
be manually rotated
1. Unscrew the left hand side and then lift and
dislodge the brush cover.
2. Lift up the left side of the rotating brush and
then remove the belt from the end of the
rotating brush.
3. Take out the rotating brush and remove the
blockage. Take out the wastes.
4. Re-install the rotating brush. Finally, check
that the brush cover is securely xed and the
rotating brush rotates properly.
7. Product Disposal
When the battery packs will no longer hold a
charge, the product has reached the end of its
useful life.
Before discarding the product, the rechargeable
battery pack must be removed and recycled in
accordance with federal and local laws, as out-
lined below.
NOTE: The battery pack is not replaceable. After
removing the battery pack, the product must be
discarded.
1. Use a screwdriver to unscrew the housing
2. Cut the wires with scissors or wire cutters in
order to free the battery compartment from the
unit completely.
3. Take out the battery compartment with motor,
Unscrew the battery bracket.
4. Remove the battery from the unit. WARNING:
Do not mutilate or incinerate the battery pack,
as it will explode at high temperatures.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk handy 2in1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk handy 2in1 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 0,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info