505726
11
Zoom out
Zoom in
Previous page
1/17
Next page
11Original Instructions
EN
DA
NO
SV
FI
DE
FR
NL
I
T
PT
E
L
T
R
C
S
H
U
P
L
HR
SL
SK
L
V
LT
ET
R
U
Z
H
In case problems other than the above occur, please contact your local Nilfi sk distributor. Local Nilfi sk distri-
butors are listed on the back cover of this instruction.
Customer Service at Penrith – 01768 868995
8 Warranty Conditions
Nilfi sk guarantees high pressure washers for domestic use for 2 years. If your high pressure washer or ac-
ces so ries are handed in for repair, a copy of the receipt must be enclosed.
Guarantee repairs are being made on the following con dit ions:
that defects are attributable to fl aws or defects in materials or workmanship. (wear and tear
as well as misuse are not covered by the gu a ran tee).
that the directions of this instruction manual have been thoroughly observed.
that repair has not been carried out or attempted by other than Nilfi sk-trained service staff.
that only original accessories have been applied.
that the product has not been exposed to abuse such as knocks, bumps or frost.
that only water without any impurities has been used.
that the high pressure washer has not been used for rental nor used com mer cial ly in any
other way.
Repairs under this guarantee include replacement of defective parts, exclusive of packing and postage/car-
riage. Besides, we refer to your national law of sale.
The machine should be forwarded to one of the service centres of the Nilfi sk organisation with description/
spe ci ca ti on of the fault.
Repairs not covered by the guarantee conditions will be invoiced. (I.e. malfunctions due to Causes men ti-
o ned in section Troubleshooting Chart of the instruction manual).
Symptom Cause Recommended action
Machine stops Fuse has blown
Incorrect mains voltage
Thermal sensor activated
Nozzle partially blocked
Replace fuse. Switch off other machines.
Check that the mains voltage corresponds
to specifi cation on the model tag.
Leave the washer for 5 minutes to cool
down.
Clean the nozzle (see section 6.2)
Fuse blows Fuse too small Change to an installation higher than the
amp. consumption of the machine.
You may try without the extension cable.
Machine pulsating Air in inlet hose/pump
Inadequate supply of mains
water
Nozzle partially blocke
Water fi lter blocked
Hose kinked
Allow machine to run with open trigger until
regular working pressure resumes.
Check that the water supply corresponds to
specifi cations required (see model tag)
NB! Avoid using long, thin hoses (min. 1/2")
Clean the nozzle (see section 6.2)
Clean the fi lter (see section 6.1)
Straighten out hose.
Machine often starts
and stops by itself
Pump/spray handle is leaking Contact your nearest Nilfi sk Service Centre.
Machine starts, but no
water comes out
Pump/hoses or accessory
frozen
No water supply
Water fi lter blocked
Nozzle blocked
Wait for pump/hoses or accessory to thaw.
Connect inlet water.
Clean the fi lter (see section 6.1)
Clean the nozzle (see section 6.2)
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk C 105.6 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk C 105.6 in the language / languages: English as an attachment in your email.

The manual is 1,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nilfisk C 105.6

Nilfisk C 105.6 User Manual - German - 17 pages

Nilfisk C 105.6 User Manual - Dutch - 17 pages

Nilfisk C 105.6 User Manual - French - 18 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info