454222
34
Zoom out
Zoom in
Previous page
1/48
Next page
B-12 / ENGLISH
B-12 - FORM NO. - 56041703 - BA 625, BA 725, BA 825
DETERGENT (EDS) SYSTEM PREPARATION AND USE
revised 1/07
COMMON INSTRUCTIONS:
The system should be purged of previous detergent when switching to a
different detergent. SERVICE NOTE: Move machine over oor drain before
purging because a small amount of detergent will be dispensed in the process.
To Purge When Changing Chemicals:
1 Disconnect and remove the detergent cartridge.
2 Turn the Key Switch (A) ON and press the Detergent Switch (F) and the
Solution Switch (B) down for at least 2 seconds. NOTE: Once activated
the purge process takes 10 seconds. See illustration on next page for
Detergent System indicators. Normally one purge cycle is adequate to
purge the system.
To Purge Weekly:
1 Disconnect and remove the detergent cartridge. Install and connect a
Cartridge lled with clean water
2 Turn the Key Switch (A) ON and press the Detergent Switch (F) and the
Solution Switch (B) down for at least 2 seconds. NOTE: Once activated
the purge process takes 10 seconds. See illustration on next page for
Detergent System indicators. Normally one purge cycle is adequate to
purge the system.
When the Detergent Cartridge is almost empty a Display Panel (D) indicator
will come on. This “Low Detergent” indicator will remain on until you reset
the system. Once this indicator comes on you should be able to simply pour
an entire gallon bottle of detergent into the Cartridge to re ll without worrying
about measuring. NOTE: Only reset the system when the cartridge is full.
When switching cartridges, the “Low Detergent” indicator is only accurate if the
replacement cartridge is at the same level as the cartridge being replaced.
To Reset:
1 Turn the Key Switch (A) ON and hold the Detergent Switch (F) down for 2
seconds. See illustration on next page for Detergent System indicators.
NON-REFILLABLE CARTRIDGE SPECIFIC INSTRUCTIONS:
Remove the Cap (AA) and place the cartridge in the detergent box. Install the
Dry Break Cap (BB) as shown.
REFILLABLE CARTRIDGE SPECIFIC INSTRUCTIONS:
Fill the detergent cartridge with a maximum of 1.25 gallons
(4.73 Liters) of detergent. SERVICE NOTE: Remove the
detergent cartridge from the detergent box prior to lling to
avoid spilling detergent on the machine.
It is recommended that a separate cartridge be used for each
detergent you plan to use. The detergent cartridges have
a white decal on them so you can write the detergent name
on each cartridge to avoid mixing them up. The detergent
cartridge has a Magnetic Slider (CC) on one end that needs
to be set to the proper dilution ratio according to the dilution
instructions on the manufacturers bottle. Slide the Magnet
Slider (CC) to the appropriate location on Detergent Dilution
Ratio Decal (DD). When installing a new cartridge, remove the
Cap (AA) and place the cartridge in the detergent box. Install
the Dry Break Cap (BB) as shown.
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk BA 625 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk BA 625 in the language / languages: English, Turkish as an attachment in your email.

The manual is 5,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info