609451
88
Zoom out
Zoom in
Previous page
1/124
Next page
26 SCRUBTEC 653B – 653BL – 651BCL – 661BL 9097058000(2)2009-10 A
ENGLISH USER MANUAL
BRUSH/PAD CLEANING
CAUTION!
It is advisable to wear protective gloves when cleaning the brush/pad because there may be sharp debris.
1. Remove the brushes/pads from the machine, as shown in Use chapter.
2. Clean and wash the brushes/pads with water and detergent.
3. Check the brushes/pads for integrity and wear; if necessary, replace them.
4. On the machines equipped with the cylindrical brush deck, remove the debris container (D, Fig. 3) by pulling it on one side with
the handle (E).
Empty and wash the debris container (D), and then install it by engaging it on the retainers.
VACUUM SYSTEM MOTOR FILTER CLEANING
1. Drive the machine on a level oor.
2. Turn the ignition key (80) to “0”.
3. Open the recovery water tank.
4. If necessary, drain the water from the tank in order to make the lter visible.
5. Check that the pre-lter is clean. If necessary clean it with water and compressed air, then install it.
6. Perform steps 1, 2 and 3 in the reverse order.
SOLUTION/CLEAN WATER FILTER CLEANING
1. Drive the machine on a level oor.
2. Turn the ignition key (80) to “0”.
3. Close the solution tap (A, Fig. 8) under the machine, behind the right rear wheel. The tap (A) is closed when it is in the position
(B) and it is open when it is in the position (C).
4. Remove the transparent cover (D), then remove the lter strainer (E). Clean and install them on the support (F).
NOTE
The lter strainer (E) must be correctly positioned on the housing (G) of the support (F).
5. Open the tap (A).
E
G
A
B
C
F
E
D
P100118
Figure 8
88


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk-ALTO SCRUBTEC 653B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk-ALTO SCRUBTEC 653B in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 9,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info