609446

Nilfisk-ALTO SCRUBTEC 545B Manual

67
Zoom out
Zoom in
Previous page
1/100
Next page
INSTRUCTIONS FOR USE ENGLISH
9097054000 - SCRUBTEC 545B / 545BL / 553B / 553BL / BOOST 5
17
02/2007
05/2015
Working with brush extra pressure function turned on
If the oor proves to be particularly difcult to clean, it is possible to turn on the brush extra pressure function by pressing the
pedal (11) to position (11c).
CAUTION!
In case of brush motor overload, due to foreign bodies which prevent them from turning, or to excessively
aggressive oors/brushes, the safety system stops the motor after about one minute of continuous overload.
The overload is shown by the three warning lights (81a, 81b, 81c) ashing simultaneously.
If the overload takes place when the extra pressure function (11c) is on, the pedal position must be changed to
(11b). If the overload persists, the brush stops.
To start scrubbing again after a brush stop due to overload, stop the machine by turning the ignition key (80) to
“0”. Turn on the machine by turning the ignition key (80) to “I”.
Battery discharge during operation
Until the green warning light (81a) stays on, the batteries allow the machine to work normally.
When the green warning light (81a) turns off, and the yellow warning light (81b) turns on, it is advisable to charge the batteries,
because the residual autonomy will last for a few minutes (depending on battery characteristics and work to be performed).
When the red warning light (81c) turns on, the autonomy is over. After a few seconds, the brush is automatically tuned off,
while the vacuum system and (only for SCRUBTEC 545BL, 553BL and BOOST 5) the drive system stay on, to nish drying the
oor and drive the machine to the appointed recharging area.
CAUTION!
Do not use the machine with discharged batteries, to avoid damaging the batteries and reducing the battery life.
TANK EMPTYING
An automatic oat shut-off system (36) turns off the vacuum system when the recovery tank (21) is full.
The vacuum system deactivation is signalled by a sudden increase in the vacuum system motor noise frequency, and the oor is
not dried.
CAUTION!
If the vacuum system turns off accidentally (for example, when the oat is activated because of a sudden
machine movement), to resume the operation: turn off the vacuum system by pressing the push-button (73),
then open the cover (22) and check that the oat inside the grid (36) has gone down to the water level. Then
close the cover (22) and turn on the vacuum system by pressing the push-button (73).
When the recovery tank (21) is full, empty it according to the following procedure.
Recovery tank emptying
1. Stop the machine.
2. Lift the brush deck by pressing the pedal (11).
3. Lift the squeegee (25) with the lever (10).
4. Drive the machine to the appointed disposal area.
5. Empty the recovery water tank with the hose (16). Then, rinse the tank with clean water.
Solution tank emptying
6. Perform steps 1 to 4.
7. Empty the solution tank with the hose (17). Then, rinse the tank with clean water.
AFTER USING THE MACHINE
After working, before leaving the machine:
1. Remove the brush as shown in the relevant paragraph.
2. Empty the tanks (20 and 21) as shown in the relevant paragraphs.
3. Perform the daily maintenance procedures (see the Maintenance chapter).
4. Store the machine in a clean and dry place, with the brush and the squeegee lifted or removed.
… 67 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk-ALTO SCRUBTEC 545B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk-ALTO SCRUBTEC 545B in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 7,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info