609446
64
Zoom out
Zoom in
Previous page
1/100
Next page
ENGLISH INSTRUCTIONS FOR USE
14
SCRUBTEC 545B / 545BL / 553B / 553BL / BOOST 5 - 9097054000
02/2007
05/2015
Pad installation/removal (for SCRUBTEC BOOST 5)
1. The machine can be equipped with pads (58) according to the type of oor to be cleaned.
2. Turn the ignition key (80) to “0”.
3. Lift the deck (57) by pressing the pedal (11).
4. Install the pads (58) so that it engages the BOOST deck.
5. To remove the pad, perform steps 2 to 4 in the reverse order.
Squeegee installation
1. Install the squeegee (25) and fasten it with the handwheels (26), then connect the vacuum hose (15) to the squeegee.
2. Adjust the squeegee with the handwheel (27) so that the rear blade - in all its length - touches the oor.
Solution or washing water tank lling
NOTE
If the machine is equipped with Chemical Mixing System (adjusting knob (77) (optional)) the tank must be lled with
clean water, otherwise the tank must be lled with solution.
3. (For machines without Chemical Mixing System)
Use the ller neck (37) to ll the tank (20) with a solution suitable for the work to be performed.
Do not ll the solution tank completely, leave few centimetres from the edge. Use the hose (17) as reference.
Always follow the dilution instructions on the label of the chemical product used to prepare the solution.
The solution temperature must not exceed 40 °C.
WARNING!
Use only low-foam and non-ammable detergents, intended for automatic scrubber applications.
(For machines with Chemical Mixing System)
Fill the tank (20) with clean water by using the ller neck (37).
Do not ll the clean water tank completely, leave a few centimetres from the edge.
The water temperature must not exceed 40 °C.
Detergent canister replacement (For machines with Chemical Mixing System)
1. Open the cover (22) and check that the recovery water tank (21) is empty, otherwise empty it with the drain hose (16).
2. Carefully lift the tank (40).
3. Unscrew the plug (46) with hose on the detergent canister (45).
4. Remove the empty canister from its housing and replace it with a new one.
5. Insert the hose properly and screw down the plug on the detergent canister.
CAUTION!
For the supply and the type of detergent to use, contact an authorised Service Center.
NOTE
In case of new system, system emptied for cleaning, etc., wait for the hoses to ll up completely before turning on.
64


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk-ALTO SCRUBTEC 545B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk-ALTO SCRUBTEC 545B in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 7,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info