609106
11
Zoom out
Zoom in
Previous page
1/27
Next page
11
NEPTUNE 7 FA
1)
Options / model variants
Original instructions
EN
400V
400V
230V
230V
Some models have the ability
to be used on either 230 Volt
or a 440 Volt power supply. On
these models confirm that the
voltage selector switch is in the
proper position to match the
power supply. Otherwise dam-
age to machines electrical com-
ponents may occur.
The following should be
observed when connecting the
high pressure washer to the
electric installation:
Only connect the machine
to an installation with earth
connection.
The electric installation
shall be made by a certified
electrician.
According to IEC 60364-1
it is strongly recommended
that the electric supply to
this machine should include
a residual current device
(GFCI).
3.13 Electrical connection
This high pressure washer/cleaner is only allowed to be connected
with the drinking watermains, when an appropriate backflow pre-
venter has been installed, Type BA according to EN 1717. If the
backflow preventer hasn’t been supplied, one can be ordered from
your Nilfisk ALTO dealer. As soon as water has flown through the
BA valve, this water is not considered to be drinking water any
more. The length of the hose between the backflow preventer and
the high pressure washer must be at least 12 metres (min diameter
3/4 inch) to absorb possible pressure peaks.
In the case of poor water quality (sand, etc.) add a water filter to
the machine.
Rinse the water supply hose briefly in order to prevent sand and
other dirt particles entering into the machine.
Operation by suction (for example from a rainwater vessel) is car-
ried out without backflow preventer. Contact your Nilfisk ALTO
dealer for suction set recommendations.
3.12 Water connection
3.13.1 Extension cables
Cable connections should be
kept dry and off the ground.
Cables on drums should always be completely unwinded to
prevent the cable from overheating. Extension cables should be
of a watertight construction and comply with the below-mentioned
requirements for length and cable dimensions.
Cable length m
Cross section
<16 A <25 A
up to 20 m ø1.5mm² ø2.5mm²
20 to 50 m ø2.5mm² ø4.0mm²
CAUTION
Do not damage the mains power lead, e.g. by driving over it,
pulling or crushing it.
Disconnect the power cord by pulling the plug only, do not
pull or tug the power cord.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk-ALTO NEPTUNE 7 FA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk-ALTO NEPTUNE 7 FA in the language / languages: English as an attachment in your email.

The manual is 1,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nilfisk-ALTO NEPTUNE 7 FA

Nilfisk-ALTO NEPTUNE 7 FA User Manual - German - 27 pages

Nilfisk-ALTO NEPTUNE 7 FA User Manual - Dutch - 27 pages

Nilfisk-ALTO NEPTUNE 7 FA User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info