608945
89
Zoom out
Zoom in
Previous page
1/112
Next page
*)
可选附件 / 选件依机型而定
原手册的翻译
89
操作说明
故障排除 MC 3C-MC 4M
故障 原因 解决办法
压力波动
吸水管内有空气。 向管内注水并重新连接
供水不足 停止!直到合适的总管道或水管指示泵 Qmax
滤水器阻塞 冲洗滤水器
高压喷嘴阻塞/磨损 清洁喷嘴或使用相同尺寸的喷嘴进行更换
超出吸入高度 停止!直到最大吸入高度达到指定值
泡沫喷射
器不产生
泡沫
所用清洗剂不起泡 仅使用含泡沫剂的清洗剂。
吸水管的喷嘴阻塞或充满干燥肥皂 清洗清洗剂限制器/使用温和清水冲洗。
泡沫喷射器中的泡沫海绵阻塞。 1 将泡沫喷射器在温和水中清洗/浸泡 8 个小时或更久
2 或卸下泡沫喷射器的前部,清洗 SS 泡沫海绵/使用
新的替换
清洗剂箱内的清洗剂已用完 加满清洗剂箱
接通电源时
电机未启动
或发出嗡
嗡声
电源线损坏 联系专业电工更换电源线
插头没有接至电源 插入插头
电源保险丝烧断 重设电源
插头与电缆连接松动 维修/重装电缆插头 - 熟练电工
泵被阻塞或冻住 停止!为泵解冻或联系经销商服务部
热保护器激活。 停止!让机器冷却至少 5 分钟
维护方案
每周 工作 50 个小时之后首次维护 每运行 200 小时 根据要求
清洁滤水器 A1.1 A1.1
检查油位/
倾斜
B1.0/E1.2
更换泵油 联系经销商/服务部 联系经销商/服务部
特殊操作说明
自吸
0: 从机器上卸下高压水管
1: 向吸水管内注满水并将其连接至高压清洗机(货号
6400000)
2: 使用水管夹将吸水管安装到泵进水口位置。
3: 将电源开关转至位置“I”数秒。重复开启关闭电源开
关数次,直至水从泵中排出。
4: 安装高压水管、喷射器手柄和喷杆。
5: 将电源开关转至位置“I”。
6: 为喷射器手柄解锁并对其操作数次,直至排出的水不
含空气。
吸水所需零部件 货号
1 x 水管喷嘴 20R 3/4¨ 61369
1 x 水管 3/4¨ 最大长度 5 米
1 x 水管夹 3/4¨
1 x 带底阀吸滤器 6400000
89


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk-ALTO MC 3C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk-ALTO MC 3C in the language / languages: All languages as an attachment in your email.

The manual is 4,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info