761688
16
Zoom out
Zoom in
Previous page
1/24
Next page
*) Optional accessories / Option depending on model
Original instruction
6
when the maximum liquid level is reached.
You will hear a noticeable change of the
sound from the motor and notice that the suc-
tion power decreases. When this occurs,
switch the machine off. Disconnect the ma-
chine from the socket. Never pick up liquid
without the float body in place.
3.4 Emptying after wet pick-up
Before emptying the container, unplug the vacuum
cleaner. Disconnect the hose from the inlet by pulling
out the hose. Release the latch by pulling them out-
wards so that the motor top is released. Open up the
motor top from container. Always empty and clean
the container and the float system after picking-up
liquids. Never pick up liquid without the float system
and filter installed in the machine.
Empty by tilting the container backwards and pour
the liquids into a floor drain or similar.
Put back the motor top to the container. Secure the
motor top with the latches.
3.5 Emptying after dry pick-up
Remove the electrical plug from the socket before
emptying after dry pick-up. Check the filters and
dustbag regularly. Release the latch by pulling them
outwards so that the motor top is released. Open up
the motor top from container.
Cartridge filter: To clean the filter you can either
shake, brush or wash it. Wait until it is dry before you
reuse it.
Dustbag: check bag to ensure the fill factor. Re-
place dust bag if necessary. Remove the old bag.
The new bag is fitted by passing the carboard piece
with the rubber membrane through the vacuum inlet.
Make sure that the rubber membrane is passing past
the heightening at the vacuum inlet.
After emptying: Close motor top to the container and
secure the motor top with the latches. Never pick up
dry material without cartridge filter and dustbag fitted
in the machine. The suction efficiency of the vacuum
cleaner depends on the size and quality of the filter
and dust bag. Therefore - use only Original filter and
dust bags.
3.6 Push&Clean
The machine is equipped with a semi automatic filter
cleaning system. Push&Clean. The filter cleaning
system must be actuated latest when the vacuum-
ing performance is no longer sufficient. Regular use
of the filter cleaning feature increases the tool life of
the filter.
4 After using the cleaner
4.1 After use
Remove the plug from the socket when machine is not
in use. Wind up the cord starting from the machine. The
power cord can be wound up around the motor top or at
the container. Some variants have special storage places
for accessories.
4.2 Transport
Before transporting the dirt tank, close all the locks.
Do not tilt the cleaner if there is liquid in the dirt tank.
Do not use a crane hook to lift the cleaner.
4.3 Storage
Store the appliance in a dry place, protected from rain
and frost.
The machine shall be stored indoors only.
Wet filters and the interior part of the liquid container
shall be dried before storage.
4.4 Recycling the cleaner
Make the old cleaner unusable.
1. Unplug the cleaner.
2. Cut the power cord.
3. Do not discard of electrical appliances with household
waste.
Equipment marked with the crossed-out wheeled
bin symbol indicates that used electrical and elec-
tronic equipment should not be discarded togeth-
er with unseparated household waste. To avoid negative
effects on human health and the environment the equip-
ment must be collected separately at the designated col-
lection points.
Users of electrical and electronic household equipment
must use the municipal collection schemes. Please note
that commercially used electrical and electronic equip-
ment, shall not be disposed of via municipal collection
schemes. We will be pleased to inform you about suitable
disposal options.
5 Maintenance
5.1 Regular servicing and inspection
Regular servicing and inspection of your machine must be
carried out by suitably qualified personnel in accordance
with relevant legislation and regulations. In particular, elec-
trical tests for earth continuity, insulation resistance, and
condition of the flexible cord should be checked frequently.
In the event of any defect, the machine MUST be with-
drawn from service, completely checked and repaired by
an authorized service technician.
5.2 Maintenance
Remove the plug from the socket before performing main-
tenance. Before using the machine make sure that the fre-
quency and voltage shown on the rating plate correspond
with the mains voltage.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk AERO 26-2L at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk AERO 26-2L in the language / languages: English as an attachment in your email.

The manual is 3.65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nilfisk AERO 26-2L

Nilfisk AERO 26-2L User Manual - German - 24 pages

Nilfisk AERO 26-2L Quick start guide - Dutch - 17 pages

Nilfisk AERO 26-2L User Manual - French - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info