604409

Nikon StabilEyes 14x40 Manual

10
Zoom out
Zoom in
Previous page
1/33
Next page
1918
How to Use and Focus
Operating System of StabilEyes
* Turning the power off automatically resets the vibration reduction mode to "Land" mode.
Press the
ON button
Press the
OFF button
Power on
The system powers up
LED
and performs a
orange
5-second system check
Power off
Stabilization is LED •
turned off off
Stabilization is LED
in standby orange
If StabilEyes is left in standby or stabilization mode for about three
minutes without using, it automatically shuts off.
Pressing the ON button causes StabilEyes
to switch from Standby to Active, or vice versa.
Stabilization LED
activated green
Press the
ON button
ON BOARD LED
mode orange
Pressing the MODE button causes StabilEyes
to switch modes, from ON BOARD to LAND, or vice versa.
LAND mode
LED
green
Press the
MODE button
1. If you wear glasses or sunglasses when
using binoculars, fold back the rubber eyecup
on each eyepiece (ocular lens) so you can view
complete images.
2. Next, grasp either eyepiece and rotate it
towards or away from the center of the
binocular (the other eyepiece will move equally
in the opposite direction.)
Adjust the interpupillary distance to match the
distance between your eyes until you see just
one perfectly round image.
3. There are two steps to focusing: Close your
right eye and use only your left eye as you
adjust the focus control knob (3). When the
image is sharp, close your left eye and open
your right eye. Twist the right eyepiece, to
focus for the right eye. Now open both eyes
and the binocular should be perfectly focused.
You can do this with the StabliEyes turned on
with stabilizing activated or with the power off
completely.
4. The StabilEyes power on/off sequence is
simple. Pressing the POWER ON button (1) the
first time activates an internal system check,
causing the LED (located between the two
eyepieces) to glow orange. Pressing the
POWER ON button a second time activates
stabilization, and the LED turns green.
The stabilization mode default is set for LAND
mode (LED : green). Pressing the MODE
button changes it to ON BOARD mode (LED :
orange). Pressing the MODE button causes
StabilEyes to switch modes, from ON BOARD
to LAND, or vice versa. Simply select the
stabilization mode that best suits your viewing
situation.
If you press the same button a third time, the
StabilEyes goes on standby (orange LED
again). Press it again, stabilization is
reactivated. You may repeat this process as
often as you wish. Reverting to standby
conserves battery power. On the other hand, if
you leave the StabilEyes in either standby or
stabilization mode for about three minutes
without using it, it will shut itself off
automatically.
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nikon StabilEyes 14x40 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nikon StabilEyes 14x40 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 4,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info