570963
15
Zoom out
Zoom in
Previous page
1/69
Next page
2928
FILM ADVANCE MODE
There are four automatic film advance modes. Hold FUNCTION
button and rotate command dial until the Function Area
indicator appears in the Film Advance Mode Area and V, Z,
X or C blinks, then hold SET/! button and rotate command
dial until desired symbol appears. Set V for single-frame
shooting, X for continuous low-speed shooting, Z for
continuous high-speed shooting, or C for silent rewind, and so
on.
V Single-frame shooting and C silent rewind
Fully depressing shutter release button takes one picture and
automatically advances film by one frame. Film is advanced
immediately after shutter closes whether you remove your
finger from shutter release button or keep the button
depressed. To take the next shot, lift your finger from the
button, then fully depress it again.
C for silent rewind is for times when conditions require a
minimum of operating noise. You can rewind film very quietly.
X Continuous low-speed and Z continuous
high-speed shooting
Shots are taken continuously as long as you keep shutter
release button fully depressed. You have a choice of shooting
speeds: approx. 3.7 fps (frames per second) in the Z mode,
and approx. 2.0 fps in the X mode—with fresh lithium
batteries at normal temperature (20˚C) and at shutter speeds of
1/250 sec. or higher in the Manual exposure and Manual focus
modes. With shutter speeds slower than 1/250 sec., the
framing rate becomes progressively slower in proportion to the
shutter speed in use.
When built-in flash is activated, continuous shooting is
automatically switched over to single-frame shooting (V). In
this case, Z or X blinks in LCD panel.
FOCUS AREA
The F70/F70D’s autofocus system offers a choice of two focus
areas: Wide and Spot.
While pressing focus area button, rotate command dial until the
desired symbol––< for Wide Area or > for Spot Area—
appears in LCD panel.
< Wide Area AF
The Wide-Area focus brackets delineate the focus detecting
area in the viewfinder. Subjects of sufficient brightness and
detail can be detected within these brackets. In addition to
general photography, autofocus using Wide-Area focus
brackets is suited to action photography in which the moving
subject requires a wide-range focus detection area.
However, focus detection may not be possible if the subject is
too small to fully cover the Wide-Area focus brackets. If various
subjects, each at a different distance, fall within the focus
detection area, focus will be confirmed for a single subject as
follows:
For subjects of equal brightness: the closer one will be
focused.
For subjects of unequal brightness: the brighter one will be
focused.
For flash photography
When built-in flash is activated or accessory Nikon
Speedlight is turned on, Wide Area is automatically
switched over to Spot Area. In this case, < blinks in
LCD panel and e appears inside viewfinder.
F70D I/MêÊçsâ¸í˘ 03.1.16 5:33 PM Page 28
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nikon F70D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nikon F70D in the language / languages: English as an attachment in your email.

The manual is 3,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info