36920
36
Zoom out
Zoom in
Previous page
1/41
Next page
71
LCD panel
Viewfinder
u blinks
appears appears
¤ appears ¤ appears
blinks blinks
q blinks
q blinks for
3 sec. after
flash
and
and q blink
q blink
Cause
Autofocus is not
possible.
Overexposure
possible.
Underexposure
possible.
Shutter speed is
set to Long Time
Exposure in S
mode.
Speedlight
recommended.
Flash has fired at
full output and
underexposure
may have
occurred.
In exposure mode
other than A or M,
flash mode
selector on the
optional
Speedlight is not
set to ¸.
Page
37
41
43
28
41
43
28
41
28
61
63
Remedy
Focus manually.
•In S mode, select
faster shutter
speed.
•In A mode, select
smaller aperture
(larger f-number).
In other exposure
modes, use ND
filter.
•In S mode, select
slower shutter
speed.
•In A mode, select
larger aperture
(smaller f-number).
In other exposure
modes, use Speedlight.
Set the shutter
speed or switch to
M mode.
Use built-in
Speedlight.
Shoot again after
confirming focus
distance, aperture
or flash shooting
distance range.
Set the
Speedlight’s flash
mode selector to
¸ or switch
exposure mode to
A or M.
70
Troubleshooting
LCD panel
Viewfinder
blinks blinks
O appears
O blinks
° blinks ° blinks
(° appears (° appears
without blinking
without blinking
in M mode) in M mode)
and T blink
and appears
blinks
T blinks
and appears
T blinks
and T blink
Cause
CPU Nikkor lens
(other than G-type) is
not set to its
minimum aperture.
Batteries are
nearing
exhaustion.
Batteries are just
about exhausted.
Non-CPU lens is
attached or lens is
not attached.
Film is not
correctly
positioned.
Non-DX-coded
film is loaded.
An exposed film
remains in the film
cartridge chamber.
Battery power is
low or temperature
is too low to
rewind film.
Page
16
15
15
16
19
19
27
35
Remedy
Set lens to
minimum aperture.
Have fresh ones
ready.
Turn the power off
and replace
batteries with new
ones.
Attach CPU lens
(except IX-Nikkor)
correctly. (Or set
the exposure
mode to Manual.)
Reload film.
Load DX-coded
film.
Remove film
cartridge.
Turn the power off
and replace
batteries with new
ones. Then, turn
the power on and
rewind film again.
In certain cases, due to static electricity or poorly loaded batteries, the F60/F60D
camera’s microcomputer may turn the camera off, even with fresh properly
installed batteries. For the same reason, film may not advance properly. In each
of these cases, to resume operation, simply turn the power off, then turn it on
again, or remove batteries and install them again.
F60 (E) 02.12.27 5:34 PM Page 70
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nikon F60 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nikon F60 in the language / languages: English as an attachment in your email.

The manual is 2,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nikon F60

Nikon F60 User Manual - German - 41 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info