619087

Niko 550-20210 Manual

15
Zoom out
Zoom in
Previous page
1/24
Next page
90
13. Indoor motion detector
To install the indoor motion detector:
1 Connect the base to the two-wire bus cable. There are two “B1” contacts and two “B2” contacts at the back of the
base. Connect each individual wire to one “B1” contact and one “B2” contact.
The base is now connected. Use the other “B1” and “B2” contacts to establish a connection to the next control
element if required.
2 Mount the base onto the single flush-mounting box using screws.
Use a bridge with a set of claws if no screw holes are provided in the flush-mounting box.
Three types of bridges are available:
• bridge 60 x 71 mm with claw connection
• bridge 71 x 71 mm with screw connection
• bridge 60 x 71 mm with screw connection
3 Press the sensor onto the base until it clicks into place.
Selecting the indoor motion detector settings
The potentiometer underneath the cover of the sensor can be used for changing the light sensitivity setting to any value
between 5 and 1200 lux.
To change these settings:
1 Open the cover.
2 Use a screwdriver to turn the potentiometer to the desired setting. Turn the potentiometer clockwise to decrease
the light sensitivity (up to a maximum of 1200 lux or daylight). Turn the potentiometer counter-clockwise to
increase the light sensitivity (up to a minimum of 5 lux or night-time).
• The indoor motion detector is for indoor use only.
• Mount the indoor motion detector at 90 - 110 cm above floor level.
• The maximum detection range is 8 m.
• Strip the wires of the bus cable 9 - 10 mm.
• A maximum of one wire with a diameter of 0.5 - 1 mm can be connected per contact.
• In this case, polarity does not matter.
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Niko 550-20210 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Niko 550-20210 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info