619234

Niko 350-20061 Manual

4
Zoom out
Zoom in
Previous page
1/5
Next page
nv Niko sa Industriepark West 40, BE-9100 Sint-Niklaas, Belgium — tel. +32 3 778 90 00 — fax +32 3 777 71 20 — e-mail: support@niko.be — www.niko.eu PM350-20061R12184
350-20061
Read the complete user manual before carrying out the installation and activating the system.
1. DESCRIPTION
The 360° presence detector (24 Vdc) for flush mounting in a ceiling uses Passive Infrared Technology
(PIR) and is suitable for indoor lighting control, such as in offices, small office areas, offices divided into work
groups, storage rooms, corridors, exhibition rooms, meeting rooms, school buildings, production halls and
cafeterias.
2. INSTALLATION
2.1. Connection
Danger: Disconnect all power before installing the presence detector. Do not connect the device to the mains
voltage until installation has been completed.
Refer to the wiring diagram (fig. 1A).
For the parallel connection of presence detectors, refer to the second wiring diagram (fig. 1B).
2.2. Mounting
Tip: Do not install the presence detector in the vicinity of heat sources such as stoves or electric heaters,
ventilation systems or moving objects (e.g. mobile phones, etc.) (fig. 2). This can activate the device
unnecessarily because the device reacts to movement and heat in its environment.
The presence detector is suitable for installation in a ceiling (fig. 3):
• in a hole with a diameter of 57 to 63 mm, or
• in a ceiling box if the clamping spring has been removed.
3. SETTINGS
3.1. Factory settings
At delivery the parameters of the presence detector are set as follows:
Parameter Factory setting
sensitivity of the motion sensor high
indication LED for motion off
3.2. DIP switches
Figure 4 shows how to set the DIP switches according to their application.
DIP switches Application
1 and 2
• Set the sensitivity of the motion sensor:
minimum, low, high or maximum.
3
• Activate the indication LED.
3.3. Indication LED for motion
Turn on DIP switch 1 and turn off DIP switch 2 to activate the indication LED for motion. The indication LED
remains illuminated as long as motion is detected.
3.4. Detection range
The presence detector is suitable for flush mounting in a ceiling. With indoor ceiling mounting at 2.5 m above
floor level, the presence detector has a detection angle of 360° and a detection range of 7 m (fig. 5).
4. OPERATION AND USE
4.1. Activating the system
The presence detector is ready for use after approximately one minute after connecting to the mains voltage
(stabilisation phase).
4.2. General operation
Depending on the type of controller connected, the presence detector switches on the lighting in the
room. When the presence detector no longer detects any motion within the detection range, the lighting is
automatically switched off after a preset time period.
5. MAINTENANCE
Dirt may prevent the presence detector from functioning properly. Therefore, always keep the lens clean and
dry. Use a damp cloth and water with some detergent to clean the lens. Never exert pressure to wipe the lens
clean. If the lens or other parts of the presence detector are defective, please contact an authorised installer.
6. TECHNICAL DATA
dimensions 24 x 90 mm (HxW) (visible portion)
power supply voltage 24 Vdc ± 10%
power consumption
worst case: < 5 mA (24 Vdc)
stand-by: < 4 mA (24 Vdc)
output contact
on/off (NPN transistor)
maximum load 50 mA (24 Vdc)
detection angle 360°
mounting height 2.5 – 4 m
detection range 7 – 12 m
protection degree IP20
protection class class II devices
ambient temperature -5 – +50°C
quality mark CE marked in compliance with EN 60669-2-1
7. WARNINGS REGARDING INSTALLATION
- The installation should be carried out by a registered installer and in compliance with the statutory
regulations.
- This user manual should be presented to the user. It should be included in the electrical installation file, and
it should be passed on to any new owners. Additional copies are available on the Niko website or via the
Niko support service.
- During installation, the following should be taken into account (non-exhaustive list):
- the statutory laws, standards and regulations.
- the technology currently available at the time of installation.
- this user manual, which only states general regulations and should therefore be read within the scope of
each specific installation.
- the rules of proper workmanship.
8. NIKO SUPPORT
In case of doubt or for the specific exchange procedure in case of a possible defect, contact the Niko support
service in Belgium at +32 3 778 90 80 or your wholesaler/installer. Contact details and more information can
be found at www.niko.eu under the “Help and advice” section.
9. GUARANTEE PROVISIONS
- The period of guarantee is four years from the date of delivery. The delivery date is the invoice date of
purchase of the product by the consumer. If there is no invoice, the date of production applies.
- The consumer is obliged to inform Niko in writing about the non-conformity, within two months after stating
the defect.
- In case of a non-conformity, the consumer only has the right to a product repair or replacement free of
charge, which shall be decided by Niko.
- Niko shall not be held liable for a defect or damage resulting from incorrect installation, improper or
careless use, incorrect operation, transformation of the product, maintenance that does not adhere to the
maintenance instructions or an external cause, such as damage due to moisture or overvoltage.
- The compulsory regulations of the national legislation concerning the sale of consumer goods and the
protection of the consumer in the countries where Niko sells, directly or via sister companies, subsidiaries,
chain stores, distributors, agents or permanent sales representatives, take priority over the above-
mentioned rules and regulations.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Niko 350-20061 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Niko 350-20061 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info