619226
21
Zoom out
Zoom in
Previous page
1/36
Next page
350-30010 350-20011
350-20010 390-20010
21
NOTE: In case of a parallel connection, only one motion sensor can
be connected to the built-in light sensor.
2.4. Cabling
Min. ±0,5mm diameter for a distance of 200m
3. OPERATION AND USE
General
- After connection to the power supply, the motion sensors are
ready for use after 1-2min (warm-up time). You can set the degree
of sensitivity by means of the setting screw (fig.11). The fabric
settings are suitable for use of the motion sensor under normal
circumstances. If the motion sensor has a degree of sensitivity
that is either too high or too low, you can optimize the detection
by means of the setting screw.
- You can test the detection zones by means of the built-in walk
test (fig.12).
Note: Test one motion sensor at a time. In test position B, the LED
lights every time the sensor detects motion. After the walk test is
finished, set the jumper to position A.
4. TROUBLESHOOTING
Problem Possible cause Proposed solution
Motion sensor fails
to switch on.
1. Incorrect connection. 1.Check whether the sensor is
connected as shown in fig.7 or 8.
2. The sensor is not
powered (24V on
terminals 1 and 2).
2.Check whether the control module is
connected correctly and the sensor
is powered.
DE
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Niko 350-20011 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Niko 350-20011 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info