Manual Niko 10-163 (page 27 of 32) (English, German, Dutch, French)

619040

Zoom out

Zoom in

1/32

10-16x

1. Remove the nameplate and carefully loosen the connector for the nameplate lighting (fig. 1).

2. Mount the external unit on the wall.

The recommended installation height for the ca-

mera is 160 to 170 cm from the ground. Run the

cable from the bottom up in the device in order to

avoid water entering the device via the cable.

3. Connect the wiring as shown in the wiring

diagram on 28.

Note: In a single system, use the same colour code

for the same terminals (a, b, P, M, V1, V2) for all

products of the Niko Access Control range.

4. You can fill out the provided blank namecard

and add it to the nameplate. Carefully open the

nameplate with a small screwdriver or with the key

provided (fig. 2).

5. Reinsert the nameplate into the external

unit.

3.2. Connecting an extra door opener relay

You can optionally connect a door opener relay

to the external unit between terminals R and P.

This relay is necessary:

• if several external units are used.

• if the external unit is to be provided with a

local door opener contact.

3.3. Six-wire/five-wire cabling

In systems of a limited size, you can choose five-wire cabling. In this case, you do not need to connect a

cable to the M-terminal. You should set up all the jumpers on the five-wire cabling configuration.

fig. 1

fig. 2

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Niko 10-163 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,59 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Niko 10-163 Manual

Product: