© Niagara Video Corporation 2016
Supported Commands
The get/set options supported by a specific device can be queried using the get help command:
hdhomerun_config <id> get help
Example output:
/card/status Get status of CableCARD (6CC only)
/oob/channel <modulation>:<freq> Get/set out of band channel (6CC only)
/oob/debug Get out of band channel debug info (6CC only)
/oob/status Get out of band channel status info (6CC only)
/sys/boot <config> Get/set boot configuration
/sys/copyright Get copyright information
/sys/debug Get/set system debug information
/sys/features Get system feature information
/sys/hwmodel Get system hardware model string
/sys/ipaddr dhcp|"<ip> <mask> <gw> <dns>" Get/set system IP address
/sys/model Get/set model string
/sys/restart <resource> Restart device/component
/sys/version Get firmware version
/tuner<n>/channel <modulation>:<freq|ch> Get/set channel
/tuner<n>/channelmap <channelmap> Get/set channelmap
/tuner<n>/debug Get tuner debug information
/tuner<n>/filter "0x<nnnn>-0x<nnnn> […]" Get/set tuner PID filter
/tuner<n>/lockkey Get/set tuner locking
/tuner<n>/plotsample Get raw plotsample data from tuner
/tuner<n>/program <program number> Get/set MPEG program
/tuner<n>/streaminfo Get list of programs on current channel
/tuner<n>/status Get tuner status
/tuner<n>/target <ip>:<port> Get/set stream target
/tuner<n>/vchannel <vchannel> Get/set virtual channel number (6CC only)
/tuner<n>/vstatus Get/set subscription/protection status (6CC only)