641177
12
Zoom out
Zoom in
Previous page
1/80
Next page
12
Front Indicators
A similar set of indicators exist in the front of the board. These are visible when the frame front
door is opened. The indicator layout is depicted below.
The LED indicators are as follows:
Status LED: indicates the overall status of the board.
o Green: no active alarm
o Red: at least one critical alarm present
When inserting a board in the frame, this LED will be red until the board starts operation.
At that point, it will turn green if there is no active alarm or red if there is at least one
alarm.
Power OK LED: indicates that the power received from the frame is OK.
o Green: power OK
o Off: no power (or insufficient voltage check the frame power status)
ASI In LED: behaves exactly the same as the ASI input rear I/O panel indicator.
ASI Out LED: behaves exactly the same as the ASI output rear I/O panel indicator.
VID LED: behaves exactly the same as the Video output rear I/O panel indicator.
Ref In LED: this LED is illuminated if all the following conditions are met:
o The BRD is configured for output genlock.
o The BRD is receiving a valid genlock signal from the selected chassis reference
input.
o The genlock signal is compatible with the selected SDI output resolution and
frame rate.
Consult the Decoder Output Configuration section later in this manual for the genlock
source selection and the SDI output configuration.
ETH LED: indicates the status of the back panel Ethernet connection.
o Off: no link
o On: link OK, no activity
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Niagara GoStream Broadcast Receiver Decoder at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Niagara GoStream Broadcast Receiver Decoder in the language / languages: English as an attachment in your email.

The manual is 2,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Niagara GoStream Broadcast Receiver Decoder

Niagara GoStream Broadcast Receiver Decoder Quick start guide - English - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info