679182
9
Zoom out
Zoom in
Previous page
1/82
Next page
6
NAZ 2.4 A1
GB
IE
6) Start in one quadrant:
Start with the brush head 2 on your gums,
and move the brush upwards/downwards
from the gums to the crown of the tooth.
Proceed in this manner on both the inside and
the outside of the tooth. Start again at the gums
for each individual tooth.
Do not forget to brush the back of the rear
molars.
To clean the chewing surfaces, guide the
rotating brush head over the chewing sur-
faces with a little pressure.
7) After 30 seconds, the toothbrush stops briefl y
to signal that you should start cleaning the
next quadrant. Clean each jaw quadrant
using the same technique.
8) After two minutes the toothbrush stops its
operation briefl y 4 times. This informs you that
you have complied with the dental recommen-
dation of two minutes cleaning.
9) Press the on/off switch 3 repeatedly until the
toothbrush stops.
10) Then take the toothbrush out of your mouth.
11) After use, rinse the brush head 2 thoroughly
under running water.
12) Remove the brush head 2 from the handset.
To clean the drive shaft and the handset,
allow a little water to fl ow over them. Hold
the handset so that the drive shaft is pointing
downwards.
NOTE
Regularly massage your gums. This promotes
blood circulation and helps to keep them healthy.
Set the mode to "Pulse" and guide the moistened
brush over your gums with a light pressure.
Cleaning and care
DANGER – ELECTRIC SHOCK!
Always remove the plug of the charger 8
from the power socket before cleaning the
appliance! Risk of electric shock!
Never submerge the handle or the
charger 8 in water or other liquids.
NOTE
Never open the housing of the charger 8 or
the toothbrush! They cannot be resealed in a
water-tight manner.
1) Clean the charger 8 only with a soft, lightly
moistened cloth. Do not use detergents or sol-
vents. They can damage the plastic surfaces.
2) Remove the brush head 2 from the handset.
After use, clean the brush heads 2 thoroughly
under running water.
We recommend cleaning the brush heads 2
in a standard commercial denture cleaning
uid every 2 - 4 weeks. A new brush head 2
should be fi tted after about 3 months, and the
brush head must always be replaced when
the bristles start to bend outwards.
3) To clean the drive shaft and the handset,
allow a little water to fl ow over them. Hold
the handset so that the drive shaft is pointing
downwards.
IB_42776_NAZ2.4A1_LB3.indb 6 12.11.14 10:14
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nevadent NAZ 2.4 A1 - IAN 42776 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nevadent NAZ 2.4 A1 - IAN 42776 in the language / languages: English, German, Dutch, Danish, French, Swedish, Finnish as an attachment in your email.

The manual is 0,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info