629274
16
Zoom out
Zoom in
Previous page
1/36
Next page
16 © 2015 UTC Fire & Security Americas Corporation, Inc. All rights reserved.
Configuring the NX-595E
You have two options to configure the device.
A direct connection with a web browser on a computer or mobile device
Via the UltraSync application on an Apple iOS or Android device
Note: Before you can utilize the UltraSync application to configure the NX-595E,
you must program in the Web Access Passcode in the Network Settings tab. It is
recommended that the initial configuration of the device be completed with a web
browser.
There is limited configuration capability with a connected keypad. Please see
Appendix 1 Advanced Setup for keypad worksheets for more information.
Configuring the NX-595E (Web browser or UltraSync)
Note: Configuration of the NX-595E with a web browser and the UltraSync
application is virtually identical. The screenshots below show the Web browser view
when configuring the device.
If you are using a computer, you can connect your computer to the same router
that the NX-595E is connected to with an Ethernet cable.
If you are using WiFi to access the network (e.g. with a tablet, WiFi enabled
computer or smart phone), make sure the WiFi router is connected to the same
network that the NX-595E is connected to.
Enter the IP address of your NX-595E into the web browser to access the NX-595E.
This is the IP address that was retrieved above in the Enrolling, Defaulting and
Retrieving the IP Address section of this document.
Figure 5
Note: The IP address that was retrieved from the device was most likely assigned
by the network router. If the router or NX-595E is reset, power cycled, or a long
period of time has expired since you retrieved the IP address, a new IP address
might be assigned to the NX-595E. If the IP address you are using is not working,
retrieve the IP address with the instruction in the Enrolling, Defaulting and
Retrieving the IP Address section of this document. You do not need to perform the
defaulting portion of these instructions when retrieving the IP address.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NetworX NX-595E IP Communication Module at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NetworX NX-595E IP Communication Module in the language / languages: English as an attachment in your email.

The manual is 0,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info