519535
10
Zoom out
Zoom in
Previous page
1/146
Next page
Table 1. LED description
LED Description
Power
Solid amber. CENTRIA is starting up.
Blinking amber.
The firmware is upgrading, or the Reset button was pressed.
Solid green. CENTRIA is ready
.
Blinking green. The
firmware is corrupted. Visit www.netgear.com/support.
Off. Power is not supplied to CENTRIA.
Internet
Solid green. The Internet connection is ready.
Solid amber.
The Ethernet cable connection to the modem has been detected.
Off. No Ethernet cable is connected to CENTRIA.
Wireless
Solid blue. The wireless radio is operating in either 2.4 GHz or 5 GHz mode.
Blinking.
The router is in WPS (WiFi protected setup) mode.
Off.
The wireless radios are off for both 2.4 GHz and 5 GHz.
USB Solid blue: The router has accepted the USB device. The USB device is ready to
be used.
Blinking blue.
A USB device is plugged in and is trying to connect.
Off. No USB device is connected; someone clicked the Safely Remove Hardware
button, and it is now safe to remove the attached USB device.
HDD
Solid green. The internal HDD is working and is not full.
Solid green plus red.
The HDD is 85% full.
Blinking green. Someone pressed the Backup button; the SD card data is being
copied to the internal HDD.
Blinking green and red.
The HDD is 95% full.
Solid red.
The HDD is not formatted, the HDD connection is loose, or there is a
failure alert.
Off. No internal HDD is connected.
Hardware Setup
10
CENTRIA WNDR4700/WNDR4720
The following are located on the side.
W
iFi On/Off button. Pressing and holding the WiFi On/Off button for 2 seconds turns on
or off the 2.4 GHz and 5 GHz wireless radios. If the Wireless LED is lit, then the wireless
radio is on. If the LED is off, then the wireless radios are turned off and you cannot
connect wirelessly to the router.
WPS button.
You can use this button to use WPS to add a wireless device or computer
to your wireless network.
Backup button.
You can use this button to back up files and folders onto the internal
hard disk drive from an SD card attached to the card reader. See Back Up an SD Card
onto the Internal HDD on page 70.
USB drive.
You can use this to attach a USB device such as a flash drive. Files and
folders on the USB device can be shared.
SD card reader.
The SD card reader supports SD, MMC, MS, or MS Pro type cards. You
can attach an SD card here, and then use the Backup button to back up files and folders
on the SD card onto the internal HDD.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Netgear WNDR4720 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Netgear WNDR4720 in the language / languages: English as an attachment in your email.

The manual is 5,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Netgear WNDR4720

Netgear WNDR4720 Installation Guide - English - 26 pages

Netgear WNDR4720 Installation Guide - German - 26 pages

Netgear WNDR4720 User Manual - German - 168 pages

Netgear WNDR4720 Installation Guide - Dutch - 26 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info