519682
122
Zoom out
Zoom in
Previous page
1/134
Next page
122 |
WG102-500, WGAP150 ProSafe™ 802.11g Wireless Access Point
Default Factory Settings
When you first receive your wireless access point, the default factory settings are set as
shown below. You can restore these defaults with the Reset button on the rear panel (see
“Rear Panel” on page 11).
Maximum Computers Per
Wireless Network
Limited by the amount of wireless network traffic generated by each node.
Typically 20-30 nodes.
Radio Data Rates
802.11b and g 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, and 54 Mbps
802.11b,g
Operating Frequencies and
Channels
2.412 ~ 2.462 GHz (North America), Channels 1-11
2.412 ~ 2.472 GHz (Europe including France and Spain, and Japan),
Channels 1-13
802.11 Security 40-bits (64-bit WEP), 104 bits (28-bit WEP), and 128-bits (152-bit WEP)
data encryption; WPA and WPA2
Table 0-1.
Feature Factory Default Settings
User Name (case sensitive) admin
Password (case sensitive) password
Operating Mode Bridge
Access Point Name NETGEAR
Built-in DHCP Server DHCP server enabled, using the default IP address
IP Configuration IP Address: 192.168.0.229
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
Network Name (SSID) 16 SSIDs: NETGEAR - 0, NETGEAR - 1, NETGEAR - 2,
and so on to NETGEAR - 15
Broadcast Network Name (SSID) Enabled
WEP/WPA Disabled
MAC Access Control Disabled
Restricting connectivity based on MAC Access
Control List
Disabled
Time Zone Coordinated Universal Time (UTC)
Specification Description
122


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Netgear WGAP150 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Netgear WGAP150 in the language / languages: English as an attachment in your email.

The manual is 3,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Netgear WGAP150

Netgear WGAP150 Installation Guide - English - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info