519671
55
Zoom out
Zoom in
Previous page
1/78
Next page
NETGEAR 54 Mbps Wireless Access Point WG602v4 Reference Manual
Advanced Configuration 4-7
v1.0, June 2007
That the LAN network configuration of each of the Wireless APs is configured to operate
in the same LAN network address range as the other LAN devices (routers, hubs and
switches).
That only one wireless access point is configured in Multi-Point Bridging mode, and that
all the others are in Point-to-Point Bridge mode.
That all APs are be on the same LAN. That is, all the wireless access point LAN IP
addresses are in the same network.
If using DHCP, all wireless access points should be set to “Obtain an IP address
automatically (DHCP Client)” in the IP Address Source portion of the Basic IP Settings
menu.
That all wireless access points are using the same SSID, Channel, WEP authentication
mode, if any, and encryption (WPA is not available in bridge modes).
That each Point-to-Point AP has the Multi-Point AP MAC address in its Remote AP MAC
address table.
If Access Control has been enabled on the APs, verify that the Wireless Cards table (MAC
Address List) for each AP is complete and accurate.
3. Verify connectivity across the LANs.
If you checked the Enable Wireless Client Association radio box on each AP, wireless
clients will be able to use the AP.
A computer on any LAN segment should then be able to connect to the Internet or share
files and printers with any other PCs or servers connected to any of the three LAN
segments.
If Access Control Lists are enabled on the APs, only computers in the access control list
will be able to use the AP.
Configuring Repeater with Wireless Client Association
In this mode, the WG602v4 will operate as a Repeater only, and send all traffic to the remote
wireless access point. You must enter the MAC address (physical address) of the remote wireless
access point.
Note: You can extend multi-point bridging by adding a total of four WG602v4 APs
configured in Point-to-Point mode to connect additional wireless LAN
segments.
55


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Netgear WG602v4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Netgear WG602v4 in the language / languages: English as an attachment in your email.

The manual is 2,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Netgear WG602v4

Netgear WG602v4 Installation Guide - English - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info