479756
27
Zoom out
Zoom in
Previous page
1/122
Next page
Reference Manual for the Model MR814 Wireless Router
Setting Up the Hardware 2-5
Detailed instructions on configuring your wireless devices for TCP/IP networking are provided in
the next chapter. However, if you already have a functioning wireless network and you wish to use
a wireless PC to initially configure the router, you will need to change the settings of that PC to
match the default settings of the router:
The SSID should be Wireless (note the capitalization).
WEP encryption is disabled.
Your IP address must be in the range of 192.168.0.2 to 192.168.0.254, with a netmask of
255.255.255.0
See Chapter 5 Wireless below for full details on setting up wireless connections.
Connecting to Your Ethernet LAN
Your Ethernet network will attach to the four LAN ports on the router shown in Figure 2-2. The
LAN ports can operate at either 10 Mbps (10BASE-T) or 100 Mbps (100BASE-Tx), depending on
the Ethernet adapters in the attached computers, hub, or switch. You must use a Category 5 (CAT5)
rated Ethernet cable, such as the cable included with the router, for any connection which will
operate at 100 Mbps.
The Model MR814 router incorporates a four-port switch for connection to your local network. To
connect the router to your LAN:
Connect up to four computers directly to any of the four LAN ports of the router using
standard Ethernet cables.
To connect more than 4 computers on the Ethernet LAN, you will need to connect your router
to another hub or switch.
Connect any Local port of your router to the Uplink port of an Ethernet hub or switch
using a standard Ethernet cable.
OR
Connect any Local port of your router to any normal port of an Ethernet hub or switch
using a crossover Ethernet cable.
Connecting to Your Internet Access Device
Using the Ethernet cable already attached to your cable modem or DSL modem, connect the
routers Internet port to the Ethernet port on the modem. Turn the modem off for ten seconds, then
on again.
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Netgear MR814 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Netgear MR814 in the language / languages: English as an attachment in your email.

The manual is 0,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info