479742
89
Zoom out
Zoom in
Previous page
1/108
Next page
Chapter 6: Troubleshooting | 89
Mobile Broadband 11n Wireless Router MBR1000 User Manual
Basic Functioning
After you turn on power to the router, the following sequence of events should occur:
1. When power is first applied, verify that the Power LED is on.
2. After approximately 10 seconds, verify that:
a. The Power LED is still solid green. A red light indicates the unit has failed its power-on
self-test (POST).
b. The Internet LED is lit.
c. The Wi-Fi radio LED is lit. The Wi-Fi radio is on by default.
d. The Ethernet LAN port LED is lit when any local ports are connected.
If a LAN port’s LED is lit, a link has been established to the connected device. If a
LAN port is connected to a 100 Mbps device, verify that the port’s LED is green. If the
port is 10 Mbps, the LED is amber.
e. The Ethernet WAN port LED is lit when the router is connected to a wired modem.
f. The Signal LED is lit when the router has detected a mobile broadband signal.
A blue LED indicates excellent coverage.
A green LED indicates good coverage.
An amber LED indicates marginal coverage.
If any of these conditions does not occur, refer to the following table.
Table 17. Troubleshooting with the LEDs
LED Action
Power Power LED is off. Make sure that the power cord is correctly connected to your router and
that the power supply adapter is correctly connected to a functioning
power outlet.
Check that you are using the power adapter supplied by NETGEAR for
this product.
If the error persists, you have a hardware problem and should contact
Technical Support.
Power LED is red. There is a fault within the router. Try to clear the fault as follows:
Cycle the power to see if the router recovers.
Clear the routers configuration to factory defaults. This sets the router’s
IP address to 192.168.0.1. This procedure is explained in
Restoring
the Default Configuration and Password on page 97.
If the error persists, you might have a hardware problem and should contact
Technical Support.
89


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Netgear MBR1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Netgear MBR1000 in the language / languages: English as an attachment in your email.

The manual is 2,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info