710889
26
Zoom out
Zoom in
Previous page
1/50
Next page
Smart Switch Series Software Manual
4-12 Web-Based Management Interface
July 2005
Switch> Advanced> Spanning Tree Page
Fast Link: When a port running the standard Spanning Tree Protocol (STP) is connected, it
will go through the STP negotiation ( listening -> learning -> forwarding or blocking ) before
it will be fully available. If a server is trying to access a client through the switch running the
STP negotiation, it will not be able to connect to it immediately. This can be a problem for
some networks. Fastlink mode solves this problem by setting the port directly to forwarding
mode, thus allowing any server access request to be forwarded. Fastlink mode can cause
temporary loops in your network, but the STP will eliminate them. Fastlink is best used on end
node ports, i.e. ports connected to PCs or servers, to avoid network loops.
Bridge Priority: Priority setting of this switch in the Spanning Tree.
Bridge Max Age: Amount of time before a configuration message is discarded by the system.
Bridge Hello Time: Interval between configuration messages sent by the Spanning Tree
algorithm.
Bridge Forward Delay: Amount of time system spends in 'learning' and 'listening' states.
Path Cost: The switch uses this to determine which port is the forwarding port. All other
factors equal, the path with the lowest cost to the root bridge will be the active path.
Path Priority: STP bases on this to determine the port to use for forwarding. The port with the
lowest number has the highest priority.
Switch> Advanced> SNMP
SNMP page allows you to limit the IP address which can access the MIB of the switch and which
the switch will send trap to. The switch will only respond to requests from computers with the IP
address in the list. You can also select the traps which the switch will send to the hosts in the
following trap events. The setting of a host will not be active until it is set to “Enable” in the
Admin field.
Trap Events :
Device bootup - The switch generates an SNMP trap when it reboots.
Authentication fail - The switch generates an SNMP trap when a host tries to gain access to the
switch but the host's IP is not in the SNMP host table.
Link Up/Down - The switch generates an SNMP trap when one of its ports changes its link
status.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Netgear GS716Tv1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Netgear GS716Tv1 in the language / languages: English as an attachment in your email.

The manual is 0,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info