810542
30
Zoom out
Zoom in
Previous page
1/37
Next page
30
3.8 Spillage test
A spillage test MUST be made before the installed fire is left with the customer.
Carry out the test by first closing all doors and windows in the room containing the stove.
Ensure that the fire is burning at full rate for a minimum of 5 minutes to warm the flue.
Using a smoke match run along the edge of the draught diverter as shown in Fig. 10 below.
The smoke should be drawn into the draught diverter. The test should be made over the full
width of the draught diverter, and the test may be done from either left or right.
Fig. 10 Spillage test (shown as rear flue, top flue draught diverter identical)
If most of the smoke is not drawn into the draught diverter leave for a further 10 minutes and
repeat.
If there is a fan in the room (or adjacent rooms) the spillage test be repeated with the fan
running on full power and all connecting doors between the fire and fan left open.
If there are problems, the chimney/flue may require attention. Isolate the stove and seek
expert advice.
The stove will produce an odour and/or smoke for the first few hours of use. Please ventilate
the room.
DRAUGHT DIVERTER
SMOKE TEST ALONG THIS EDGE
SMOKE TEST
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nestor Martin TQH14 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nestor Martin TQH14 in the language / languages: English as an attachment in your email.

The manual is 5.45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info