810545
26
Zoom out
Zoom in
Previous page
1/33
Next page
GB & IE
4. Servicing
Turn the appliance OFF and isolate the gas supply. Ensure the appliance is fully cold before attempting to start
servicing the appliance. No liability can be accepted by Nestor Martin for injury caused by burning or scolding by
a hot appliance.
A suggested procedure for servicing is listed below.
A. Lay out dust sheet on flooring, mask off any special fireplace materials.
B. Open Outer Firebox Door.
C. Carefully remove the Ceramic components (including Embers) or Gravels
D. Use a Vacuum cleaner to clean the top of the burners and grate
E. Remove Grate
F. Use the vacuum cleaner and a soft brush to clean the pilot assembly and both Injectors. It may be easier
to access the Injector by removing the Throttle. Never modify or bend the Thermocouple.
G. Clean the Window Panel.
H. Turn on the gas supply and check for leaks, check the burners and Pilot for good condition and operation
I. Replace Grate
J. Replace the Firebed arrangements
K. Close doors.
L. Check the flue system and terminal, making sure that the terminal vent is fully clear
M. Light the appliance and test setting pressures
N. Check the safe operation of the appliance.
4.1 Cleaning the Ceramics
Remove the ceramics as detailed in A - E above.
Gently clean the ceramics in the open air, using a soft brush and a vacuum cleaner. Where necessary replace
damaged components only with genuine Nestor Martin specified parts. Seal any scrap ceramics in plastic bags
and dispose at proper refuse sites. When using a vacuum cleaner, it is recommended that one with a HEPA
filtering system is used.
Re-fit the Firebed arrangement, re-seal the appliance and check the safe operation of the appliance.
4.2 Servicing the Burner
A fault finding chart is included in the appendix for the Mertik control system fitted to this appliance.
Access the Burner as detailed in A - F above.
The pilot is now clearly visible, the pilot, including the Thermocouple, can be replaced/serviced by removing
raising the pilot assembly from its mounting. This is done by removing the two screws on the surface of the
pilot. The fittings on the under-side of the pilot can be un-done using a 10mm spanner where appropriate.
The Main Burner Injectors can be accessed from the underside of the appliance. If the burner requires to be
removed, this may be done by removing the 4 M6 fixings inside the firebox (10mm Spanner), the burner will lift
out through the Firebox.
When replacing any parts use only original Nestor Martin specified parts.
4.3 Spare parts
For spare parts, contact your Nestor Martin dealer directly to specify the desired spare part
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nestor Martin THS15 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nestor Martin THS15 in the language / languages: English as an attachment in your email.

The manual is 4.27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info