810514
59
Zoom out
Zoom in
Previous page
1/77
Next page
C07100DC023
58
3. LIGHTING AND OPERATING
FAILURE TO IGNITE
The system will fail to ignite if there is insufficient or too much oil in the burner or because of an electrical power
failure.
When no oil (or an excess of oil) is present, check the setting of the carburator. Also, its arming lever and supply
line should be examined for faults.
Do not repeatedly attempt to ignite a burner if it fails to light. If no cause is found in the burner, a suitable
qualified technician should be consulted.
Before lighting
- Check that the valve on the tank is open,
- Check that the setting lever on the float chamber is in the upward position.
LIGHTING
A. Open the front door only slightly.
B. Turn the control knob to position 1 (minimum) - this will allow fuel to enter the burner/s. As soon as fuel
enters the burner (after about one minute) the fuel must be ignited.
C. To ignite the fuel use either a small piece of fire lighter, a taper or a well lighter match. The lighted item must
be placed at the base of the pot
D. Close the front door after about 2-3 minutes (depending on the draft).
Warning: The door may be left ajar only during lighting. The door must stay closed throughout the normal
operation of the appliance. As the appliance requires a good chimney draught, it is imperative to allow the
chimney to be thoroughly warmed before increasing the distributor control knob settings.
With a chimney which is new or has not been used for a long period, it is adviseable to leave the appliance at
minimum setting for up to 1 hour.
In cases of an already warm chimney or recently used appliance, only 10-15 minutes will be required.
Note: If on lighting from cold a large smokey flame develops and persists and does not clear, the oil supply should
be isolated to extinguish the fire. The chimney should then be examined for blockage or other means of poor flue
draught.
EXTINGUISHING
1. Turn the control knob to position 0.
2. Shut the reservoir tap.
59


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nestor Martin S21 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nestor Martin S21 in the language / languages: English, Dutch, French as an attachment in your email.

The manual is 4.75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info