571164
16
Zoom out
Zoom in
Previous page
1/24
Next page
16
FUELS
APPROVED FUELS
Your appliance has been designed to burn the following approved fuels:
Recommended solid fuels: beech wood, birch, oak, ash, hornbeam and wood from fruit trees.
Non-recommended solid fuels: conifer, damp wood, chemically treated wood, shavings, wood pellets, coke. It
is prohibited to burn refuse or ammable liquids (petrol, solvents or motor oil) inside the stove.
CHOICE OF WOODS TO BURN
The best wood to burn is very dry wood which will be easier to light and will cause less tarring/sooting in the chimney.
Ideally the wood will have been left to dry for 18 months, and even in that case the logs will still have a moisture
content of 20%!
Damp wood not only has a lower calori c power, which lowers the combustion temperature, and therefore is less
ef cient, it is also dif cult to light, extinguishes easily and gives off smoke. Above all, the use of damp wood can lead to
soot being deposited in the smoke ducts (tarring and sooting) of the chimney.
Some woods are more reactive than others. Those that are best are hornbeam, beech and oak. Aspen, birch and lime
tree burn well but do not last as long. After them are soft leaves and conifers. The diameter of the log is important for
the heat. However, this classi cation is only an indication as the best re wood is always the driest.
Wood provided at a ready-to-use length, stored immediately in a well aired place, dry quicker than those left in steres.
Blocks dry quicker than logs. Wood chucks that are too small to be split must be drained. To do this, remove a portion
of the bark.
Drying the wood will take between 18 months and 2 years. This time can be shortened (12 to 15 months) if the wood is
cut to a ready-to-use length and immediately stored in a well aired place
TARRING AND SOOTING
When the smoke reaches a low temperature in the chimney, part of the water vapours that it contains condense. The
heaviest components of this are deposited on the inside of the ue. This is TARRING. The mix oxidizes in contact with
the air and forms brownish marks. This is SOOTING.
To avoid this inconvenience four things must be done: use only dry wood, connect the stove to achimney with thick sides
and at an even section (the bushel 20 x 20cm system is often used) and make sure that the connecting tubes are as
short as possible.
The chimney ue must be inspected frequently during the heating season (i.e. summer months) to determine if a build-
up of creosote is forming. If a creosote deposit of 3 1/8” (3mm) or more forms, it must be removed to reduce the risk of
chimney re.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nestor Martin IQH33 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nestor Martin IQH33 in the language / languages: English as an attachment in your email.

The manual is 1.05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nestor Martin IQH33

Nestor Martin IQH33 User Manual - Dutch - 25 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info