810534
31
Zoom out
Zoom in
Previous page
1/37
Next page
31
Servicing
4. Servicing
Turn the appliance OFF and isolate the gas supply. Ensure the appliance is fully cold before
attempting to start servicing the appliance. No liability can be accepted by Nestor Martin for injury
caused by burning or scolding by a hot appliance.
A suggested procedure for servicing is listed below.
A. Open the door
B. Carefully remove the Ceramic components (including Embers) or Gravels
C. Use a Vacuum cleaner to clean the top of the burners and grate
D. Remove Grate
E. Using a vacuum cleaner, fully clean the burner. The Pilot assembly is now clearly
visible. Use the vacuum cleaner and a soft brush to clean the pilot assembly. Never modify or bend
the Thermocouple
F. Turn on the gas supply and check for leaks, check the burner and Pilot for good
condition and operation
G. Replace Grate
H. Replace the Firebed arrangements
I. Close the door
J. Check the flue system and terminal, making sure that the terminal vent is fully clear
K. Light the appliance and test setting pressures
L. Check the safe operation of the appliance.
4.1 Cleaning the Ceramics
Remove the ceramics as detailed in A - B above.
Gently clean the ceramics in the open air, using a soft brush and a vacuum cleaner. Where necessary
replace damaged components only with genuine Nestor Martin specified parts. Seal any scrap
ceramics in plastic bags and dispose at proper refuse sites. When using a vacuum cleaner, it is
recommended that one with a HEPA filtering system is used.
Re-fit the Firebed arrangement, re-seal the appliance and check the safe operation of the appliance.
4.2 Servicing the Burners
The pilot is now clearly visible, the pilot, including the Thermocouple, can be replaced/serviced by
removing raising the pilot assembly from its mounting. This is done by removing the two nuts (M5,
8mm spanner) followed by removing the pilot shield and the pilot clamp.
To access the Burner Injector, the Burner must be removed. This is done by removing the four bolts
(M6, 10mm spanner) holding the burner in. With these four bolts removed, the Burner base can be
raised up through the Firebox, and the Injectors can be easily accessed.
When replacing any parts use only original Nestor Martin specified parts.
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nestor Martin H44 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nestor Martin H44 in the language / languages: English as an attachment in your email.

The manual is 5.45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info