571185
16
Zoom out
Zoom in
Previous page
1/48
Next page
16
5. CLEANING & MAINTENANCE
WARNING: DO NOT CLEAN STOVE WHILE HOT.
Always keep the area around the unit clean and clear
of furniture and other objects. Keep all furniture and
drapery a minimum of one metre from the stove. Clean
the stoves surface using light strokes of a real bristle
paint brush. Stoves with a cast black finish should never
be cleaned with a cloth as the texture of the paint will
abrade and collect lint from the cloth which will be
almost impossible to remove. Stoves with an enamel
finish should be cleaned with a damp cloth, or very
gentle use of a cleaner recommended for enamel
finishes. In case of condensation, clean the affected
areas before they dry.
Inspect the entire unit frequently for proper operation,
fit and soundness of parts. If any malfunctioning,
cracked, broken, or loose parts or other problems are
noted, contact your dealer or qualified serviceman to
inspect and repair the unit. DO NOT OPERATE THE
UNIT IF INSTALLED OR FUNCTIONING IMPROPERLY.
Seals
Check the fit and seal of the doors and ashpan door
frequently. For proper operation an airtight seal must
be maintained around these openings. If the seal is not
tight, inspect the gasket. If the gasket needs
replacement, contact your dealer. If the gasket is in
good condition, check the closure latch screws; if these
are loose, adjust the door handle (Fig. 24).
Glass
Your stove is fitted with 4 mm ceramic glass. Properly
operated, your glass door will not get coated with thick
tar like conventional stoves. If this does occur, you may
have to resort to using a glass cleaner. However, by
using dry wood, much of the tar on the glass will burn
clean, when the appliance is run at high temperature.
Clean the ceramic glass when cold, using commercial
products sold for this purpose, or warm water with a
drop of vinegar.
The glass used in your stove is ceramic, which can only
be broken due to a strong blow or a bad use. Inspect
the glass regularly. If it detects that it is damaged,
replace the glass using a new glass seal kit immediately.
WARNING: Replacement of damaged glass must be
done with original parts supplied by your dealer. Use
of other materials could cause a safety hazard and
void your warranty.
CAUTION: NEVER OPERATE YOUR STOVE WITH
BROKEN GLASS.
Replacement of the glass:
1. Open the door. Lift off the stove body.
2. Remove the 4 fixing screws and remove the the
glass and old seals.
3. Replace the seals and glass.
4. Install the 4 screws. Do not over tighten the
screws.
Fig. 23
Note: When replacing glass, always replace glass seals
Any maintenance or adjustment, not described in this
manual, must be performed by a trained and
competent technical service engineer.
Door handle adjustment (see Fig. 24)
The stoves are equipped with an adjustable door latch.
For correct operation, the stove door must be airtight
when closed.
To adjust the door handle latch:
1. Loosen the locking nut.
2. Adjust the bolt in or out as required. The
adjustment should be made in such way that
when the handle is in its closed position the door
is airtight and the handle vertical.
3. Re-tighten the locking nut.
Fig. 24
Handle
shaft
Bolt
Latch
Locking nut
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nestor Martin H43 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nestor Martin H43 in the language / languages: English, Spanish as an attachment in your email.

The manual is 4.82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nestor Martin H43

Nestor Martin H43 User Manual - Dutch, French - 25 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info