22 - English
English
Installation of the IRT 30
5. Installation of the IRT 30
This chapter is important for installers and may also be of
interest to some users.
5.1 Mounting
1. Check the contents of the package
The package should contain the following:
- 1 clock thermostat IRT 30 with mounting plate
- 1 bag with 2 screws, 2 washers and 2 plugs
- this manual.
2. Find a suitable mounting position
The thermostat should be mounted to an inside wall at a distance
of approximately 150 cm above the floor. Consider the following
when searching for a suitable mounting position:
- There should be enough air circulation around the thermostat,
but no draught!
- The air temperature should be representative for the whole
room.
- Do not mount the thermostat too near heat sources like
radiators, hot water pipes, tv sets, radios, fire places, lamps or
incoming sunlight.
- Do not mount the thermostat too near cold sources like walls
of unheated rooms, cold water pipes and draught.
- Do not mount the thermostat in a blind corner of the room.
- Mount the thermostat on a flat surface.
3. Install the wiring
Switch off the power supply of the boiler before you install the
wiring!
Install the cable between the boiler and the thermostat. Do not
connect the cable yet!
