Assembly Instructions
6
For the installer and kitchen
expert!
Important installation notes:
❑ Properly dispose of packaging
materials.
❑ Do not use oven door handle for trans-
porting or handling the unit during
installation.
❑ WARNING: Connection and first start of
the appliance may only be performed by
an authorised specialist.
❑ Connection must be made using an
H05VV-F mains connection cable.
❑ Rated consumption, rated voltage
and type no. of the appliance:
See appliance nameplate behind the
oven door to the left beneath the side
edge of the oven.
❑ The unit's nameplate is located at on
the right sidewall of the unit.
❑ Electrical safety of the appliance can
be ensured only if the equipment earth
in the building installation has been
installed according to regulations.
❑ On the installation side a separating
device shall be provided.
Any switch with a contact gap ex-
ceeding 3 mm may be considered
aseparating device.
Other examples are LS switches, fuses
and contactors.
❑ In the case of repairs interrupt all
power connections to the unit.
❑ The connection diagram is located on
the rear panel of the appliance.
Connectable built-in hobs
❑ Cooking surface and appliance must be
from the same manufacturer and
marked with a point on the instructions
sticker. Otherwise functional failures will
result. They must have the same rated
voltage (see nameplate).
Furniture programmes
Cooker conversion cabinets from virtually
all lines of kitchen furniture are suitable for
installing the built-in cooker. However, the
veneers or plastic laminates on the con-
version cabinets must be applied with heat-
resistant cement (90 C). If plastic laminates
or cement are not sufficiently heat-resistant,
warping, bubbling or detachment of the
finish may result.
Based on the testing regulations for heat
exposure, the unit complies with type Y.
