7
2. Open the Nedis SmartLife app on your phone.
3. Create an account with your mobile phone number or your e-mail address
and tap Continue.
4. Enter the received verication code.
5. Create a password and tap Done.
6. Tap Add Home to create a SmartLife Home.
7. Set your location, choose the rooms you want to connect with and tap Done.
Installation of the product (image B + C)
1. Open the cover (A
1
).
2. Unscrew the casing screws (A
2
).
3. Take the two halves of the casing apart.
4
Make sure the power cable is not connected to an electricity supply before
connecting it to the product.
4. Cut away rings from the sealing cap (A
6
) until the hole matches the
diameter of the power cable.
5. Slide A
6
over the power cable.
4
The maximum diameter of A
6
is 21 mm.
6. Insert the power cable into the cable hole (A
3
).
7. Push A
6
into A
3
8. Use a small screwdriver or pin to open the holes of C
2
.
9. Connect the positive and negative wires of the power cable to C
2
10. Use a small screwdriver or pin to open the holes of C
1
.
11. Connect the ground wire of the power cable to C
1
.
12. If desired, attach the lower half of the casing to a wall.
13. Reassemble the product.
14. Connect the power cable to an electricity supply.
4
The installation can be tested by repeatedly pressing A
7
. If the power cable
has been successfully connected, the product will switch on and o and
make a clicking noise.
Add the product to the SmartLife app
1. In the Nedis SmartLife app, tap + in the top right corner.
2. Under Add Manually, select Smart Plug.
3. Check if the indicator LED is blinking rapidly. If so, tap to conrm.
4. If A
4
does not blink rapidly, press and hold A
7
for 5 seconds and check
again.
