812862

Nedis PASH120BKA4 - Paper Shredder Manual

3
Zoom out
Zoom in
Previous page
1/28
Next page
3
a Quick start guide
Paper Shredder PASH120BKA4
For more information see the extended manual
online: ned.is/pash120bka4
Intended use
The Nedis PASH120BKA4 is intended to cut up to 6 sheets of A4-size
paper into strips or ne particles at once.
This product is not intended to shred cardboard or thick paper
sheets.
This product is intended for indoor use only.
This product is not intended for use by persons (including children)
with a reduced physical, sensory or mental capabilities or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning the use of the product by a person
responsible for their safety.
Any modication of the product may have consequences for safety,
warranty and proper functioning.
Specications
Product Paper Shredder
Article number PASH120BKA4
Dimensions (l x w x h) 325 x 170 x 322 mm
Weight 3260 g
Power supply 220 - 240 VAC / 50/60 Hz
Power input 1.4 A
Power consumption 300 W
Operating cycle 2 minutes on / 60 min o
Cutting style Cross cut
Entry width 220 mm
Shred capacity 6 sheets of 80 g of paper size A4
Main parts (image A)
Control slider
Paper entry
Shredder
Carrying handle
Container
Power cable
Safety instructions
-
WARNING
• Ensure you have fully read and understood the instructions in
this document before you install or use the product. Keep this
document for future reference.
• Only use the product as described in this document. Any other
use may cause (serious) injuries.
• Do not use the product if a part is damaged or defective. Replace
a damaged or defective product immediately.
• Do not drop the product and avoid bumping.
• This product may only be serviced by a qualied technician for
maintenance to reduce the risk of electric shock.
• Ensure that there is sucient light when installing and using the
product.
• Position the product close to a power outlet, so the power cable
can be unplugged easily.
• Make sure the power cable is positioned in a way that prevents
tripping or falling.
• Unplug the product from the power source and other equipment
if problems occur.
• Do not unplug the charger by pulling on the cable. Always grasp
the plug and pull.
• Connect to a grounded outlet only.
• Do not let the power cable touch hot surfaces.
• Do not expose the product to direct sunlight, naked ames or
heat.
• Do not expose the product to water or moisture.
• Do not immerse the product in water or other liquids.
• Do not use the product if the surface is cracked.
• Place the product on a stable and at surface.
• Do not overll the container. Empty the container before using
the product again.
• Be careful when handling the blades.
• Keep away from the paper entry to avoid cutting injuries.
• Keep clothing, necklaces, bracelets, loose hair and any other
object that can get stuck away from the paper entry.
• Do not insert explosive materials, metal objects, or any other
foreign objects that can lead to hazardous situations.
• Before cleaning and maintenance, switch o the product and
disconnect the power.
• When the product is not in use, disconnect it and store in a safe,
dry place, out of reach from children.
• Keep the product out of reach from children, inrm persons or
animals.
• Do not let pets or children play too close to the product.
• This product is not a toy. Never allow children or pets to play with
this product.
• Children should be supervised to ensure that they do not play
with the product.
• Do not move the product during operation.
• Do not use a damaged or defective product, but return it for
repair or replacement.
Installing the product
1. Place the product on a stable and at surface.
2. Connect the power cable A6 to a power outlet.
Using the product
1. Slide the control slider A1 to AUTO.
Standby mode is activated.
2. Insert max. 6 A4-size sheets of paper vertically into the paper
entry A2 at once.
The product detects the paper and starts shredding.
-
Do not hold on to the paper when it is being shredded.
After shredding, the product returns to the standby mode
automatically.
Reversing the product
When paper is jammed in the shredder A3, you can reverse the
shredder blades to remove the paper.
1. Slide A1 to REV.
The product starts to reverse the running.
A1 slides to OFF.
2. Slide A1 to AUTO.
3. Insert max. 6 A4-size sheets of paper vertically into A2 at once.
Troubleshooting
The product is
switched on, but
the paper cannot be
shredded.
There is too much
cut paper into the
container A5. The
paper cannot fall
down and stays at
A2.
1. Disconnect the
product.
2. Remove A3
from A5.
3. Empty A5
above a dust bin.
3 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nedis PASH120BKA4 - Paper Shredder at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nedis PASH120BKA4 - Paper Shredder in the language / languages: All languages as an attachment in your email.

The manual is 0.95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info