534830
43
Zoom out
Zoom in
Previous page
1/64
Next page
41
- TYPE C -
SEWING ON BUTTONS
No. 23 Regular Foot
1. Lower the feed dogs by moving the drop
feed lever to the left.
2. Attach the regular foot and align two holes
of button with slot of presser foot.
3. Push the button located on the right side
of foot and lower the foot to hold the
button securely.
4. Adjust the stitch width so that the needle
enters the left hole of button.
5. Turn hand wheel by hand so needle
enters the second hole. You may need to
adjust the stitch width again.
CAUTION: To prevent accidents.
Make sure that the needle does not hit the
button during sewing. Otherwise needle may
break.
6. Sew approximately 10 stitches at slow
speed.
7. Raise the foot and cut the threads
remaining about 10 cm to the fabric.
8. Pull the end of bobbin thread and pull
upper thread to the wrong side of fabric.
Tie them together.
9. After sewing, move the drop feed lever to
the right.
Note:
To sew a 4-hole button, follow the procedure
avobe for the first two holes. Then lift presser
foot slightly and move fabric to permit
stitching the other two holes, either
independently, or criss-cross over the first
two holes.
A. Thread Shank
Sew-through buttons on coats and jackets
should have a thread shank to make them
stand away from the fabric. Place a straight
pin or sewing machine needle on top of
button between the holes, and sew over the
pin or needle.
Pull thread to back of button and wind
around stitches to form a firm shank. Tie
thread ends securely.
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Necchi 424 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Necchi 424 in the language / languages: English as an attachment in your email.

The manual is 3,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info