215367
132
Zoom out
Zoom in
Previous page
1/150
Next page
120
8. Appendix
Troubleshooting
This section helps you resolve problems you may encounter while setting up or using the projector.
Indicator Messages
Power Indicator
Indicator Condition Projector Condition Note
Off The main power is off.
Blinking light
Green
0.5 sec On,
0.5 sec Off
The projector is getting ready to turn on. Wait for a moment.
2.5 sec On,
0.5 sec Off
Off Timer (Off Time) is activated.
Orange
0.5 sec On,
0.5 sec Off
The projector is cooling down. Wait for a moment.
2.5 sec On,
0.5 sec Off
The Program Timer is activated.
Steady light
Green The projector is turned on.
Orange The projector is in Standby.
Status Indicator
Indicator Condition Projector Condition Note
Off
Normal or Standby ([POWER-SAVING] for [STANDBY
MODE])
Blinking light
Red
1 cycle (0.5 sec
On, 2.5 sec Off)
Lamp cover error
Reattach the lamp cover correctly.
( page
119)
2 cycle (0.5 sec
On, 0.5 sec Of)
Temperature error
The projector is overheated. Move
the projector to a cooler location.
4 cycle (0.5 sec
On, 0.5 sec Off)
Fan error Fans will not work correctly.
6 cycle (0.5 sec
On, 0.5 sec Off)
Lamp error
Lamp fails to light. Wait a full min-
ute and then turn on again.
Green Re-fi ring the lamp The projector is re-fi ring.
Steady light
Orange
Control Panel Lock is on
You have pressed cabinet button
when Control Panel Lock is on.
( page
101)
CONTROL ID error
Remote control ID and projector ID
are not matched.
Green
Standby ([NORMAL] for [STANDBY MODE])
Lamp Indicator
Indicator Condition Projector Condition Note
Off Normal
Blinking light Red
Lamp has reached its end of life. Lamp replace-
ment message will be displayed.
Replace the lamp.
(
page 117)
Steady light
Red
Lamp has been used beyond its limit. The projec-
tor will not turn on until the lamp is replaced.
Replace the lamp.
(
page 117)
Green Lamp is in Eco mode
Over-Temperature Protection
If the temperature inside the projector rises too high, the over-temperature protector will automatically turn off the
lamp with the STATUS indicator blinking (2-cycle On and Off.)
Should this happen, do the following:
Unplug the power cable after the cooling fans stop.
Move the projector to a cooler location if the room where you are presenting is particularly too warm.
Clean the ventilation holes if they are clogged with dust.
Wait about 60 minutes until the inside of the projector becomes cool enough.
132


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nec vt800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nec vt800 in the language / languages: English as an attachment in your email.

The manual is 13,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info