214807
32
Zoom out
Zoom in
Previous page
1/75
Next page
24
Adjusting with the Auto Keystone Function
The Auto Keystone correction feature will correct the vertical distortion of a projected image on the screen. No special
operation required. Just put the projector on a flat surface.
TIP: Even when the menu setting for [Auto Keystone] is turned on, [Keystone] can be adjusted manually.
To turn on [Auto Keystone], proceed the following steps.
1. Press the MENU button
The menu will be displayed.
2. Press the SELECT
̄
button to select [Setup] and press the ENTER button.
The [General] tab will be highlighted.
3. Press the SELECT
̄
button.
The [Auto Keystone] will be highlighted.
4. Press the SELECT
̇
or
̈
button to select [On].
5. Press the MENU button.
The menu will be closed.
NOTE:
•Vertical distortions between offset angles of +/- 30 degrees can be corrected.
The Auto Keystone correction will take effect in 2 seconds after changing the projection angle during projection.
The left and right (horizontal) keystone correction is not available.
Place the projector so that the lens surface is parallel to the screen.
The rear feet of the projector can be adjusted to level the projector.
NOTE:
Auto and Manual Keystone correction angle could be less than 30 degrees depending on the signal and/or aspect ratios.
Using keystone correction can cause the image to be slightly blurred because the correction is made electronically.
NOTE:
When the menu is displayed, the Keystone Correction operation is not available by using the buttons on the projector cabinet.
When the menu is displayed, press the EXIT button to close the menu and then perform the Keystone correction.
From the menu, select [Setup]
[General]
[Keystone]. The changes can be saved with [Keystone Save].
(
page 42)
TIP: If you have one of the following conditions, the projector’s Auto Keystone may not be performed correctly.
The screen is tilted
The room temperature is too high or too low
The optical zoom is maximized or minimized
3. Projecting an Image (Basic Operation)
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nec vt 700 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nec vt 700 in the language / languages: English as an attachment in your email.

The manual is 3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info