536498
137
Zoom out
Zoom in
Previous page
1/149
Next page
127
8. Appendix
Common Problems & Solutions
(“Power/Status/LampIndicator”onpage126.)
Problem CheckTheseItems
Does not turn on
or shut down
• Checkthatthepowercordispluggedinandthatthepowerbuttonontheprojectorcabinetortheremotecontrol
is on� ( pages 15, 16)
• Ensurethatthelampcoverisinstalledcorrectly.( page 122)
• Checktoseeiftheprojectorhasoverheated.Ifthereisinsufcientventilationaroundtheprojectororiftheroom
where you are presenting is particularly warm, move the projector to a cooler location�
• Checktoseeifyoucontinuetousetheprojectorforanother100hoursafterthelamphasreachedtheendofits
life� If so, replace the lamp� After replacing the lamp, reset the lamp hours used� ( page 120)
• Thelampmayfailtolight.Waitafullminuteandthenturnonthepoweragain.
• Set[FANMODE]to[HIGHALTITUDE]whenusingtheprojectorataltitudesapproximately5500feet/1700meters
or higherUsing the projector at altitudes approximately 5500 feet/1700 meters or higher without setting to [HIGH
ALTITUDE] can cause the projector to overheat and the projector could shut down� If this happens, wait a couple
minutes and turn on the projector� ( page 92)
If you turn on the projector immediately after the lamp is turned off, the fans run without displaying an image for
some time and then the projector will display the image� Wait for a moment�
Will turn off • Ensurethatthe[OFFTIMER]or[AUTOPOWEROFF]isoff.( page 88, 95)
No picture
• UsetheCOMPUTER,theHDMI,theVIDEOortheS-VIDEObuttonontheremotecontroltoselectyoursource
(Computer, HDMI1, HDMI2, Video or S-Video)� ( page 18) If there is still no picture, press the button again�
• Ensureyourcablesareconnectedproperly.
• Usemenustoadjustthebrightnessandcontrast.( page 81)
• Resetthesettingsoradjustmentstofactorypresetlevelsusingthe[RESET]intheMenu.( page 102)
• EnteryourregisteredkeywordiftheSecurityfunctionisenabled.( page 31)
• BesuretoconnecttheprojectorandnotebookPCwhiletheprojectorisinstandbymodeandbeforeturningon
the power to the notebook PC�
In most cases the output signal from the notebook PC is not turned on unless connected to the projector before
being powered up�
* If the screen goes blank while using your remote control, it may be the result of the computer’s screen-saver
or power management software�
• Seealsothenext page
Picture suddenly be-
comes dark
• CheckiftheprojectorisintheForcedECOmodebecauseoftoohighambienttemperature.Ifthisisthecase,
lower the internal temperature of the projector by selecting [HIGH] for [FAN MODE]� ( page 92)
Color tone or hue is un-
usual
• Checkifanappropriatecolorisselectedin[WALLCOLOR].Ifso,selectanappropriateoption.( page 87)
• Adjust[HUE]in[PICTURE].( page 81)
Image isn’t square to the
screen
• Repositiontheprojectortoimproveitsangletothescreen.( page 20, 21)
• UsetheKeystonecorrectionfunctiontocorrectthetrapezoiddistortion.( page 23)
Picture is blurred
• Adjustthefocus.( page 20)
• Repositiontheprojectortoimproveitsangletothescreen.( page 20, 21)
• Ensurethatthedistancebetweentheprojectorandscreeniswithintheadjustmentrangeoftheprojectionwindow.
( page 103, 104)
• Condensationmayformonthelensiftheprojectoriscold,broughtintoawarmplaceandisthenturnedon.
Should this happen, let the projector stand until there is no condensation on the lens�
Fli c k e r app e a r s on
screen
•
Set [FAN MODE] to other than [HIGH ALTITUDE] mode when using the projector at altitudes approximately 5500 feet/1700
meters or lower� Using the projector at altitudes less than approximately 5500 feet/1700 meters and setting to [HIGH ALTI-
TUDE] can cause the lamp to overcool, causing the image to flicker� Switch [FAN MODE] to [AUTO]� ( page 92)
Image is scrolling ver-
tically, horizontally or
both
• Checkthecomputer’sresolutionandfrequency.Makesurethattheresolutionyouaretryingtodisplayissupported
by the projector� ( page 133)
• AdjustthecomputerimagemanuallywiththeHorizontal/Verticalinthe[IMAGEOPTIONS].( page 83)
Remote control does
not work
• Installnewbatteries.( page 10)
• Makesuretherearenoobstaclesbetweenyouandtheprojector.
• Standwithin22feet(7m)oftheprojector.( page 10)
Indicator is lit or blink-
ing
• SeethePOWER/STATUS/LAMPIndicator.( page 126)
Cross color in RGB
mode
• PresstheAUTOADJ.buttonontheprojectorcabinetortheremotecontrol.( page 25)
• Adjustthecomputerimagemanuallywith[CLOCK]/[PHASE]in[IMAGEOPTIONS]inthemenu.( page 82)
137


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nec UM330X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nec UM330X in the language / languages: English as an attachment in your email.

The manual is 6,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nec UM330X

Nec UM330X Quick start guide - English, German - 6 pages

Nec UM330X User Manual - German - 149 pages

Nec UM330X Quick start guide - Dutch, Danish - 6 pages

Nec UM330X Quick start guide - French - 6 pages

Nec UM330X User Manual - French - 149 pages

Nec UM330X Quick start guide - Italian - 6 pages

Nec UM330X User Manual - Italian - 149 pages

Nec UM330X Quick start guide - Polish - 6 pages

Nec UM330X User Manual - Polish - 149 pages

Nec UM330X Quick start guide - Portuguese - 6 pages

Nec UM330X User Manual - Portuguese - 149 pages

Nec UM330X Quick start guide - Swedish - 6 pages

Nec UM330X User Manual - Swedish - 149 pages

Nec UM330X Quick start guide - Turkish - 6 pages

Nec UM330X Quick start guide - Spanish - 6 pages

Nec UM330X User Manual - Spanish - 149 pages

Nec UM330X Quick start guide - Finnish - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info