542936
219
Zoom out
Zoom in
Previous page
1/231
Next page
207
9. Appendix
Common Problems & Solutions
(“Power/Status/LampIndicator”onpage206.)
Problem CheckTheseItems
Does not turn on or
shut down
• Checkthatthepowercordispluggedinandthatthepowerbuttonontheprojectorcabinetortheremotecontrol
is on� ( pages 14, 15)
• Ensurethatthelampcoverisinstalledcorrectly.( page 162)
• Checktoseeiftheprojectorhasoverheated.Ifthereisinsufcientventilationaroundtheprojectororiftheroom
where you are presenting is particularly warm, move the projector to a cooler location�
• Checktoseeifyoucontinuetousetheprojectorforanother100hoursafterthelamphasreachedtheendofits
life� If so, replace the lamp� After replacing the lamp, reset the lamp hours used� ( page 160)
• Thelampmayfailtolight.Waitafullminuteandthenturnonthepoweragain.
• Set[FANMODE]to[HIGHALTITUDE]whenusingtheprojectorataltitudesapproximately5500feet/1700meters
or higher� Using the projector at altitudes approximately 5500 feet/1700 meters or higher without setting to [HIGH
ALTITUDE] can cause the projector to overheat and the projector could shut down� If this happens, wait a couple
minutes and turn on the projector� ( page 108)
If you turn on the projector immediately after the lamp is turned off, the fans run without displaying an image for
some time and then the projector will display the image� Wait for a moment�
Will turn off • Ensurethatthe[OFFTIMER]or[AUTOPOWEROFF]isoff.( page 103, 111)
No picture
• UsetheCOMPUTER1,theCOMPUTER2,theVIDEOortheS-VIDEObuttonontheremotecontroltoselectyour
source (Computer, Video or S-Video)� ( page 17) If there is still no picture, press the button again�
• Ensureyourcablesareconnectedproperly.
• Usemenustoadjustthebrightnessandcontrast.( page 95)
• Ensurethatthelenscoverisopen.( page 5)
• Resetthesettingsoradjustmentstofactorypresetlevelsusingthe[RESET]intheMenu.( page 117)
• EnteryourregisteredkeywordiftheSecurityfunctionisenabled.( page 33)
• BesuretoconnecttheprojectorandnotebookPCwhiletheprojectorisinstandbymodeandbeforeturningon
the power to the notebook PC�
In most cases the output signal from the notebook PC is not turned on unless connected to the projector before
being powered up�
* If the screen goes blank while using your remote control, it may be the result of the computer’s screen-saver
or power management software�
• Seealsothenext page
Picture suddenly
becomes dark
• CheckiftheprojectorisintheForcedECOmodebecauseoftoohighambienttemperature.Ifthisisthecase,
lower the room temperature by turning down your air conditioner
Color tone or hue is
unusual
• Checkifanappropriatecolorisselectedin[WALLCOLOR].Ifso,selectanappropriateoption.( page 102)
• Adjust[HUE]in[PICTURE].( page 95)
Image isn’t square to
the screen
• Repositiontheprojectortoimproveitsangletothescreen.( page 19)
• UsetheKeystonecorrectionfunctiontocorrectthetrapezoiddistortion.( page 24)
Picture is blurred
• Adjustthefocus.( page 21)
• Repositiontheprojectortoimproveitsangletothescreen.( page 19)
• Ensure that the distance between the projector and screen is within the adjustment range of the lens.
( page 143)
• Condensationmayformonthelensiftheprojectoriscold,broughtintoawarmplaceandisthenturnedon.
Should this happen, let the projector stand until there is no condensation on the lens�
Flicker appears on
screen
• Set[FANMODE]tootherthan[HIGHALTITUDE]modewhenusingtheprojectorataltitudesapproximately5500
feet/1700 meters or lowerUsing the projector at altitudes less than approximately 5500 feet/1700 meters and
setting to [HIGH ALTITUDE] can cause the lamp to overcool, causing the image to flicker� Switch [FAN MODE] to
[AUTO]� ( page 108)
Image is scrolling
vertically, horizontally
or both
• Checkthecomputer’sresolutionandfrequency.Makesurethattheresolutionyouaretryingtodisplayissupported
by the projector� ( page 214)
• AdjustthecomputerimagemanuallywiththeHorizontal/Verticalinthe[IMAGEOPTIONS].( page 97)
Remote control does
not work
• Installnewbatteries.( page 9)
• Makesuretherearenoobstaclesbetweenyouandtheprojector.
• Standwithin22feet(7m)oftheprojector.( page 9)
Indicator is lit or blinking
• SeethePOWER/STATUS/LAMPIndicator.( page 206)
Cross color in RGB
mode
• PresstheAUTOADJ.buttonontheprojectorcabinetortheremotecontrol.( page 26)
• Adjustthecomputerimagemanuallywith[CLOCK]/[PHASE]in[IMAGEOPTIONS]inthemenu.( page 96)
Formoreinformationcontactyourdealer.
219


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nec P401W at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nec P401W in the language / languages: English as an attachment in your email.

The manual is 11,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nec P401W

Nec P401W Quick start guide - English - 6 pages

Nec P401W Quick start guide - English - 6 pages

Nec P401W Quick start guide - German - 6 pages

Nec P401W User Manual - German - 231 pages

Nec P401W Quick start guide - Dutch, Danish - 6 pages

Nec P401W Quick start guide - French - 6 pages

Nec P401W User Manual - French - 231 pages

Nec P401W Quick start guide - Italian - 6 pages

Nec P401W User Manual - Italian - 231 pages

Nec P401W Quick start guide - Polish - 6 pages

Nec P401W User Manual - Polish - 231 pages

Nec P401W Quick start guide - Portuguese - 6 pages

Nec P401W User Manual - Portuguese - 231 pages

Nec P401W Quick start guide - Swedish - 6 pages

Nec P401W User Manual - Swedish - 231 pages

Nec P401W Quick start guide - Turkish - 6 pages

Nec P401W User Manual - Turkish - 231 pages

Nec P401W Quick start guide - Spanish - 6 pages

Nec P401W User Manual - Spanish - 231 pages

Nec P401W Quick start guide - Finnish - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info