216193
127
Zoom out
Zoom in
Previous page
1/158
Next page
6. Maintenance
112
Replacing the Lamps
When a lamp reaches the end of it’s usable life, the following message is displayed. Re-
place the lamp.
The projection lamps should be replaced when they burn out. They should only be re-
placed with a certified replacement part (NP12LP), contact your local dealer if unsure.
Note:
1. Lamps are positioned differently. Take care not to force the lamps when replac-
ing.
2. Installation of both lamp modules (Lamp 1 and Lamp 2) is required to operate
the projector in dual or single lamp mode. If only a single lamp module is installed,
the projector's lamp will not turn on and will appear as a lamp failure
3. Lamps last approximately 2000-2100 hours (3000-3100 hours in Eco mode)
and the End of lamp life message is displayed during the lamps' final 100 hours of
operational life. Please replace during 2000-2100 hour.
Important:
1. The lamp contains a certain amount of mercury and should be disposed of ac-
cording to local ordinance regulations.
2. Avoid touching the glass surface of the new lamp: doing so may shorten its op-
eration life.
3. If the lamp’s useful life ends and projector could not turn on over 2100 hours,
please have the projector serviced.
Note:
The projector turns off and goes into standby mode after 2100 hours (up to 3100
hours in Eco mode) of service. In this condition you cannot clear the lamp hour
meter using the menu. Should this condition exist, press the HELP button on the
remote control for 10 seconds to reset the lamp clock back to zero.
Ensure the lamp is replaced before performing this operation.
127


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nec np4100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nec np4100 in the language / languages: English as an attachment in your email.

The manual is 7,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nec np4100

Nec np4100 Quick start guide - English, German - 2 pages

Nec np4100 User Manual - German - 157 pages

Nec np4100 Quick start guide - French - 2 pages

Nec np4100 User Manual - French - 157 pages

Nec np4100 Quick start guide - Italian - 2 pages

Nec np4100 User Manual - Italian - 157 pages

Nec np4100 Quick start guide - Swedish - 2 pages

Nec np4100 User Manual - Swedish - 157 pages

Nec np4100 Quick start guide - Spanish - 2 pages

Nec np4100 User Manual - Spanish - 157 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info