493591
98
Zoom out
Zoom in
Previous page
1/115
Next page
87
8. Appendix
Common Problems & Solutions
(
“POWER/STATUS/LAMPIndicator”onpage86)
Problem CheckTheseItems
Does not turn on
or shut down
• Checkthatthepowercableispluggedinandthatthepowerbuttonontheprojectorcabinetortheremotecontrol
is on� ( pages 20, 21)
• Ensurethatthelampcoverisinstalledcorrectly.( page 81)
• Checktoseeiftheprojectorhasoverheated.Ifthereisinsufcientventilationaroundtheprojectororifthe
room where you are presenting is particularly warm, move the projector to a cooler location�
• Checktoseeifyoucontinuetousetheprojectorforanother100hoursafterthelamphasreachedtheendof
its life� If so, replace the lamp� After replacing the lamp, reset the lamp hours used� ( page 76)
• Thelampmayfailtolight.Waitafullminuteandthenturnonthepoweragain.
• Set[FANMODE]to[HIGHALTITUDE]whenusingtheprojectorataltitudesapproximately5500feet/1600meters
or higherUsing the projector at altitudes approximately 5500 feet/1600 meters or higher without setting to
[HIGH ALTITUDE] can cause the projector to overheat and the projector could shut down� If this happens, wait
a couple minutes and turn on the projector� ( page 70)
If you turn on the projector immediately after the lamp is turned off, the fans run without displaying an image
for some time and then the projector will display the image� Wait for a moment�
Will turn off • Ensurethatthe[OFFTIMER]or[AUTOPOWEROFF]isoff.( page 72, 73)
No picture • UsetheCOMPUTER1,theCOMPUTER2,theCOMPUTER3,theVIDEOortheS-VIDEObuttonontheremote
control to select your source (Computer, Video or S-Video)� ( page 23) If there is still no picture, press the
button again�
• Ensureyourcablesareconnectedproperly.
• Usemenustoadjustthebrightnessandcontrast.( page 56)
• Removethelenscap.
• Resetthesettingsoradjustmentstofactorypresetlevelsusingthe[RESET]intheMenu.( page 76)
• EnteryourregisteredkeywordiftheSecurityfunctionisenabled.( page 35)
• BesuretoconnecttheprojectorandnotebookPCwhiletheprojectorisinstandbymodeandbeforeturning
on the power to the notebook PC�
In most cases the output signal from the notebook PC is not turned on unless connected to the projector before
being powered up�
* If the screen goes blank while using your remote control, it may be the result of the computer’s screen-saver
or power management software�
• Seealsothenext page
Picture suddenly
becomes dark
• CheckiftheprojectorisintheForcedECOmodebecauseoftoohighambienttemperature.Ifthisisthecase,
lower the internal temperature of the projector by selecting [HIGH] for [FAN MODE]� ( page 70)
Color tone or hue is
unusual
• Checkifanappropriatecolorisselectedin[WALLCOLOR].Ifso,selectanappropriateoption.( page 64)
• Adjust[HUE]in[PICTURE].( page 56)
Image isn’t square to
the screen
• Repositiontheprojectortoimproveitsangletothescreen.( page 24)
• UsetheKeystonecorrectionfunctiontocorrectthetrapezoiddistortion.( page 28)
Picture is blurred • Adjustthefocus.( page 26)
• Repositiontheprojectortoimproveitsangletothescreen.( page 24)
• Ensure that the distance between the projector and screen is within the adjustment range of the lens.
( page 82, 83)
• Condensationmayformonthelensiftheprojectoriscold,broughtintoawarmplaceandisthenturnedon.
Should this happen, let the projector stand until there is no condensation on the lens�
Flicker appears on
screen
•
Set [FAN MODE] to other than [HIGH ALTITUDE] mode when using the projector at altitudes approximately 5500 feet/1600
meters or lowerUsing the projector at altitudes less than approximately 5500 feet/1600 meters and setting to [HIGH
ALTITUDE] can cause the lamp to overcool, causing the image to flicker� Switch [FAN MODE] to [AUTO]� ( page 70)
Image is scrolling
vertically, horizontally
or both
• Checkthecomputer’sresolutionandfrequency.Makesurethattheresolutionyouaretryingtodisplayissup-
ported by the projector� ( page 95)
• AdjustthecomputerimagemanuallywiththeHorizontal/Verticalinthe[IMAGEOPTIONS].( page 59)
Remote control does
not work
• Installnewbatteries.( page 10)
• Makesuretherearenoobstaclesbetweenyouandtheprojector.
• Standwithin22feet(7m)oftheprojector.( page 10)
• Checkifoneormoreremotesensorsareenabled.Select[SETUP] [INSTALLATION] [REMOTE SENSOR]
from the menu� ( page 68)
• Makesurethattheremotecontrol'sIDcorrespondswiththeprojector'sID.( page 68)
Indicator is lit or blinking • SeethePOWER/STATUS/LAMPIndicator.( page 86)
Cross color in RGB
mode
• PresstheAUTOADJ.buttonontheprojectorcabinetortheremotecontrol.( page 30)
• Adjustthecomputerimagemanuallywith[CLOCK]/[PHASE]in[IMAGEOPTIONS]inthemenu.( page 58)
Formoreinformationcontactyourdealer.
98


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nec NP3200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nec NP3200 in the language / languages: English as an attachment in your email.

The manual is 7,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nec NP3200

Nec NP3200 Quick start guide - English, German - 6 pages

Nec NP3200 User Manual - German - 115 pages

Nec NP3200 Quick start guide - Dutch, Danish - 6 pages

Nec NP3200 Quick start guide - French - 6 pages

Nec NP3200 User Manual - French - 115 pages

Nec NP3200 Quick start guide - Italian - 6 pages

Nec NP3200 User Manual - Italian - 115 pages

Nec NP3200 Quick start guide - Polish - 6 pages

Nec NP3200 Quick start guide - Portuguese, Swedish - 6 pages

Nec NP3200 User Manual - Swedish - 115 pages

Nec NP3200 Quick start guide - Turkish - 6 pages

Nec NP3200 Quick start guide - Spanish - 6 pages

Nec NP3200 User Manual - Spanish - 115 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info