170484
145
Zoom out
Zoom in
Previous page
1/266
Next page
User Guide
145
www.nec-computers.com
Preparing IDE Devices
Note: Please note that in normal operation mode, the ‘cable
select’ position is recommended for all IDE devices.
Preparing an IDE Optical Drive
Before installing a CD/DVD-ROM drive in the system, the jumper on the back of the
drive must be set as “cable select”.
Refer to the “Jumper settings (example)” hereafter for details about configuring IDE
drives as master or slave.
Refer to the instructions printed on the device for further jumper setting information.
Figure 43: Connectors on the Back of an Optical Drive (example)
A - Jumper block
Figure 44: Jumper settings (example)
A - Master
B - Slave
C - Cable select
Preparing an IDE Tape Drive
Before installing a tape drive in the system, it should be set as a master or a slave
device using the drive select jumper at the back of the drive.
145


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nec express5800 tm800 nl at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nec express5800 tm800 nl in the language / languages: English as an attachment in your email.

The manual is 2,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info