512544
7
Zoom out
Zoom in
Previous page
1/11
Next page
8 NAVMAN W100 User Manual
Calibration Procedures
Linearisation of the Wind Sensor and
Instrument
Each wind direction sensor has slightly different
electrical characteristics. To provide a highly
accurate display of wind direction data these
characteristics must be entered into the wind
display. This process is called linearisation.
Alignment of the Wind Vane and Display
It is very difficult to align the mast head
transducer in an exact fore and aft position during
installation on the mast. The NAVMAN W100
allows the user to carry out adjustments to the
displayed wind direction after the transducer is
installed.
Wind Speed Calibration
The NAVMAN W100 wind speed transducer is
factory calibrated to read the correct wind speed
under normal conditions. If necessary the user
is able to make adjustments to the wind speed
reading.
Note:
When first installing the NAVMAN W100, the
Linearisation should be performed first,
followed by Alignment then Wind Speed.
Wind Speed
Press and hold the and keys for 3
seconds.
3 SECS
To increase reading press the key.
To decrease reading press the
key.
Each key press results in a 5% change. It may
take 2 or 3 key presses before a change to the
speed can be observed.
To exit press the
key.
Alignment
Whilst in Wind Speed mode, momentarily press
the
and keys.
AP
Press the and keys to change the
displayed wind direction.
To exit press the
key.
Linearisation
Whilst in Alignment mode, press the and
keys until the display shows LE. The display will
flash for 6 seconds before displaying LE.
6 SECS
Rotate the wind vane through two complete
revolutions to allow the NAVMAN W100 to
perform the automatic linearisation process. The
vane can be rotated in either direction.
To exit press the
key.
Note:
If there is any doubt about the accuracy
of the display wind direction, repeat the
linearisation & alignment calibration
procedures.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Navman Wind 100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Navman Wind 100 in the language / languages: English as an attachment in your email.

The manual is 0,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info