28502
83
Zoom out
Zoom in
Previous page
1/88
Next page
TRACKFISH 6500 Installation and Operation Manual 83
NAVMAN
c A fuel transducer may be clogged. If so,
remove the transducer from the fuel line
and gently blow through it in the opposite
direction to the fuel flow.
A fuel filter between the fuel transducer
and the fuel tank must be installed as per
the fuel installation guide. Failure to do so
will void the warranty.
d Inspect the fuel cable from end to end for
damage such as cuts, breaks, trapped or
squashed sections.
e Check that the fuel filter is clean.
3-3 A twin engine installation shows only one
flow rate:
a Check that the number of engines is set to 2
(see section 17-5).
3-4 Erratic Fuel Flow readings:
a The fuel flow transducer may have been
mounted too close to the fuel pump or may
be subject to excessive vibration. Refer to
the installation instructions supplied with
the fuel transducer.
b Check for leaks in the fuel line or in the fuel
pickup in the tank.
c The Flow filter value is not suitable for
the engine. Check that the value is not set
to zero, then try increasing the value until a
steady flow rate is shown (see section 17-5).
3-5 There is no reading for fuel economy:
a The boat must be travelling through the
water to generate an Economy reading.
b Check that the paddlewheel on the
transducer is spinning freely and that the
two magnets in the paddlewheel are still in
place.
B-4 Sonar fishfinding problems
4-1 The TRACKFISH operates erratically:
a Check that the transducer does not have
debris (e.g. weed, plastic bag) caught
around it.
b The transducer may have been damaged
during launching, running aground or
while underway with debris etc. If the
transducer has been impacted, it may have
been kicked up on the bracket. If it is not
physically damaged, reset the transducer
back to its original position. (See the
Transom Transducer Installation Guide.)
c When the transducer is less that 2 ft (0.6 m)
from the bottom, the depth readings may
become inconsistent and erratic.
d Manual Gain may be set too low, which may
cause weak bottom echo or no fish signals. If
in Manual Gain, try increasing the Gain.
e Ensure the back of the bottom surface
of the transducer is slightly lower than
the front and the front is as deep in the
water as possible in order to minimize the
generation of bubbles through cavitation.
(See the Transom Transducers Installation
Guide)
f Check the transducer and power cable
connectors at the back of the display unit
are securely plugged in and the collars are
locked in place. The collars must be secure
for watertight connection.
g Inspect the power cable from end to end
for damage such as cuts, breaks, squashed
or trapped sections.
h Ensure there is not another fishfinder
or depth sounder turned on, which may
interfere with this TRACKFISH.
i Electrical noise from the boat’s engine or
an accessory may be interfering with the
transducer(s) and/or the TRACKFISH. This
may cause the TRACKFISH to automatically
decrease the Gain unless using Manual
Gain.
The TRACKFISH thus eliminates weaker
signals such as fish or even the bottom
from the display. This may be checked
by switching off other instruments,
accessories (e.g. bilge pump) and the
motor until the offending device is
located. To stop problems from electrical
noise, try:
83


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Navman TRACKFISH_6500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Navman TRACKFISH_6500 in the language / languages: English as an attachment in your email.

The manual is 2,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Navman TRACKFISH_6500

Navman TRACKFISH_6500 User Manual - German - 88 pages

Navman TRACKFISH_6500 User Manual - Dutch - 88 pages

Navman TRACKFISH_6500 User Manual - French - 89 pages

Navman TRACKFISH_6500 User Manual - Italian - 90 pages

Navman TRACKFISH_6500 User Manual - Swedish - 87 pages

Navman TRACKFISH_6500 User Manual - Spanish - 91 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info