Manual Navman Trackfish 6600 (page 60 of 83) (English)

512557

Zoom out

Zoom in

1/83

TRACKFISH 6600 Installation and Operation Manual 61

NAVMAN

Press MENU once or more until the Setup

menu is displayed, then select Calibrate:

The fuel

options can

be calibrated

only when

the optional

single or twin

engine kit is

installed on

petrol/gasoline

engines.

Speed

This calibrates the speed from the paddlewheel

transducer. Calibration may be required

because different hull shapes have different

flow characteristics.Obtain an accurate

measurement of the boat's speed from a GPS

receiver; or by following another boat travelling

at a known speed; or by making a timed run

over a known distance.

Note: for accurate calibration:

• The speed from a GPS receiver should be

greater than 5 knots.

• The speed from another paddlewheel

transducer should be between 5 and

20 knots.

• Best results are achieved in calm

conditions where there is minimal current

(best at high or low tide).

Press or to change the displayed speed

to the true value.

Speed filter

Waves and wind cause the boat speed from

the paddlewheel transducer to ﬂ uctuate slightly.

To give stable readings, the TRACKFISH

calculates these values by taking several

measurements and averaging them. Set the

Speed ﬁ lter to the lowest value which gives

stable readings. The range is 1 to 30 seconds

or Off (0).

Temperature

The factory settings should be sufﬁ ciently accurate

for normal usage. To calibrate the temperature

readout, ﬁ rst measure the water temperature with

a thermometer known to be accurate.

Use the cursor keys

to display the temperature

readout box,

then increase or decrease the

15-11 Setup > Calibrate

value to match the measured temperature. The

temperature can be set from 32° to 99.9°F (0°

to 37.7°C) with a resolution of 0.1° unit.

To change the units between °F (Fahrenheit)

or °C (Celsius), see section 15-9.

Temperature filter

Water turbulence and currents cause the water

temperature to ﬂ uctuate slightly. To give stable

readings, the TRACKFISH calculates these

values by taking several measurements and

averaging them. Set the Temperature ﬁ lter to

the lowest value which gives stable readings.

The range is 1 to 30 seconds or Off (0).

Fuel

Calibrating the fuel usage can improve the

accuracy of fuel measurements.

Twin engine installations require each fuel

transducer to be calibrated. This can be done

at the same time with two portable tanks or at

different times using one portable tank.

Calibrating the fuel transducer(s) requires

accurate measurement of the fuel consumption.

This is best done using a small portable tank. At

least 4 gallons (15 litres) of fuel should be used

to ensure an accurate calibration.

It is often very difﬁ cult to ﬁ ll underﬂ oor tanks

to the same level twice due to air pockets,

so the more fuel used, the more accurate

the calibration.

To calibrate the fuel transducer(s), perform the

following steps:

1. Record the level of the fuel in the tank(s).

2. Connect the portable tank(s) to the

engine through the fuel transducer(s).

3. Run the engine at normal cruising speed

until at least 4 gallons (15 litres) of fuel

has been used per engine.

4. Check the actual amount of fuel used per

engine by reﬁ lling the portable tank(s) to

the original level and noting the reading(s)

from the fuel dispenser’s gauge.

5. Select Fuel. Use the cursor keys to

change the reading for each engine to

match that on the fuel dispenser’s gauge.

6. Press ENTER when the reading

is correct.

Note: If the fuel calibration options appear

to give erroneous readings after a while,

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Navman Trackfish 6600 in the language / languages: English as an attachment in your email.

The manual is 0,57 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Navman Trackfish 6600

Navman Trackfish 6600 User Manual - German - 76 pages

Navman Trackfish 6600 User Manual - Dutch - 81 pages

Navman Trackfish 6600 User Manual - Italian - 81 pages

Navman Trackfish 6600 User Manual - Swedish - 78 pages

Navman Trackfish 6600 User Manual - Spanish - 81 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Navman Trackfish 6600 Manual

Product: